how to upload/download parameters using a PC from the FMU90 Level transmitter.
@brennersouza366
5 жыл бұрын
Hello, could you please tell me the basic configuration for the language change. Thank you in advance.
@brennersouza366
5 жыл бұрын
I'm from Brazil
@endresshauser
5 жыл бұрын
Olá tudo bem? Você deve seguir este caminho: Main menu>Device Properties>Language>Portuguese. Porém, este é um opcional no instrumento e pode não aparecer para você, pois não temos a certeza de que você possui o pacote de idioma. Para isso, entre em contato com o suporte técnico da Endress+Hauser no Brasil - acesse: www.br.endress.com/pt/fale-conosco
@mohdanaskhan6086
8 жыл бұрын
Hi sir the sensor is not showing actual value at scada. please help me find out the problem
@benjaminscher6333
8 жыл бұрын
+Mohd Anas khan:Is it reading the correct level on the display? If it is, then, I would suggest that you check the actual output of the FMU90. If you get a good output signal from the FMU90, then, the problem is downstream of the output and within the wiring between the device and the SCADA system. If you measure it from the output of the device and there is no output, and if you simulate an output, and there is still no output, then, you have a problem with the electronics of the device, and it would be time to replace them.
@kids-enjoy779
7 жыл бұрын
Hai Sir, could you help me how to set curve settings
@seanbeeker4980
7 жыл бұрын
Hi Vardhan. Thanks for the question. It probably would be easiest to have our Technical Support team explain this to you directly, as the answer will depend on your requirements. Can you email us at techsupport@us.endress.com, or give us a call at +1 317 363 7377? Thank you!
Пікірлер: 8