Absolutely outstanding! The information, pace and delivery were spot on, as was the solution. You took something that many will feel is difficult and dangerous, and made it understandable and straightforward. Well, done and a subscription well earned.
@esmailbosspro8066
6 ай бұрын
I get so excited when you post
@zippi777
5 ай бұрын
Thanks as always for these usefull guides!
@jwspock1690
4 ай бұрын
TNX for the video
@bast7486
3 ай бұрын
suuper easy to uunderstand. Great Work. :)
@techadsr
6 ай бұрын
My three node Proxmox cluster had a ceph cluster using three USB attached 1TB nvme drives, one per node. I was experimenting with it as a reduction in single point of failure vs NFS on a Synology NAS. Ran fine for about a week. Then one drive "failed". Quotes because testing the drive after removing it showed it was good. Maybe it overheated? Unknown but Proxmox ceph said it was down. Thought about how I would repair it but ultimately didn't find out how to replace the one failed drive. Now that you've shown how before it actually fails hard, I may rebuild the ceph cluster. If the failure happens again, I'll try to replace it using your example here in this video. Thanks
@kristof9497
6 ай бұрын
Thanks for the video.
@yarinik
6 ай бұрын
Thank you for the video
@PerNilsson1
6 ай бұрын
Great video!
@eovermeer
5 ай бұрын
Great tutorial, is this the way to go to replace my 3-node Ceph disks from NVMe 256GB to 1TB?
@heselmas
2 ай бұрын
Should work.
@hafizrafiyev6935
6 ай бұрын
Hello,why did you reboot pve1 in order to replace osd disk?is reboot mandatory?
@MRPtech
6 ай бұрын
If your proxmox nodes supports "hot-swap" of drives then you don't need to shut it down. In my case i have 3x Beelink Mini PCs. I can't replace a drive while node is running. I need to shut it down -> replace the drive -> start node
Пікірлер: 13