Can you help me get the imo off program or tell me where to
@myroad5469
2 ай бұрын
Hello i think for EDC15c2 1 plug We just need to immo off on eeprom !?
@UnixCoDElectronics
2 ай бұрын
Yes in general for one plug ecu only eeprom is required, even if you only remove eep, car will also start on some old sw edc15c2 (1 plug ) for PSA. But for other 3 plug is required eep+flash.
@myroad5469
2 ай бұрын
@@UnixCoDElectronics thank you very much
@bypass9690
2 ай бұрын
what tool did you use to read this?
@irfankhalifa5647
12 күн бұрын
Hi, Where do you get the solder adapter for the 44 pin flash chip i cant find it...
@UnixCoDElectronics
12 күн бұрын
Hi, for what programmer ? Because in general there are no compatible between programmers.
@irfankhalifa5647
12 күн бұрын
@@UnixCoDElectronics Thank you for the quick reply this is for the xgecu t48 programmer...
@autolivepost
4 ай бұрын
ПРИВЕТ ДРУГ ХОРОШАЯ РАБОТА .. ПОЖАЛУСТА ПОДЕЛИСЬ ЭТОЙ ПРОГРАММОЙ СО МНОЙ
@UnixCoDElectronics
4 ай бұрын
Hello, the software it is shared for free on cartechnology forum, the owner will provide also activation of software for free.
Пікірлер: 11