I’m changing from graphite to steel iron. Shafts and would like to give the graphites to my older friend. Thanks for that
@M.M.Alam.Liberty
9 ай бұрын
Excellent tips. thank you.
@CrazedBonana
16 күн бұрын
Does someone have the link to the video where he does this with the pings he was talking about?
@StockDude
5 ай бұрын
So all plastic do-dads have to be taken off and replaced when removing a shaft? I've got a bubble head driver that I want to remove from a graphite shaft. Thanks for the vid. It was informative!
@mdrretired
Жыл бұрын
Ever use a heat gun? Softer heat and less chance to debond the shaft epoxy. Pretty narrow range between the two epoxies. Just wondered.
@dawnpatrolgolf
Жыл бұрын
Just getting into tinkering with my own clubs, replacing shafts, grips, heads, driver adapters, etc... Maybe I'll take this further as I've done a little bit of work for friends. Having said that, any recommendations for a shaft puller?
@YugiohDude11212
Жыл бұрын
Put the club in the shaft extractor under pressure , then use the propane until it lets go , no guess work
@briansgolfworks4991
Жыл бұрын
You are EXACTLY correct. This allows you to use minimal heat for the process.
@davidrose9125
Жыл бұрын
Interesting!
@thomascecchino7066
Жыл бұрын
If you take out a steel shaft and replace it with a graphite one, How will this effect swing weight since Ultimately that's what I am trying to reduce going to graphite? Also how would I know if the replacement graphite shaft should be a tapered tip?
@briantorney980
Жыл бұрын
Most heads are parallel except Titleist, Mizuno, Srixon, XXIO and some Taylor made. I keep shaft ends TT and parallel to confirm fit. If you are going from steel to graphite shafts you will need a swing weight machine to properly weight the shafts.
@neomaxi_zoomdweebi
Жыл бұрын
Are you trying to reduce total club weight or swing weight? There is a difference. Just going to a lighter graphite shaft while using the same head and grip can increase swing weight while lowering total club weight.
@briantorney980
Жыл бұрын
When reshafting from steel to graphite two things will happen. You will reduce the club weight and increase the swingweight. To maintain SW you can drill the head or add a counter balance weight.
@StockDude
5 ай бұрын
If you're not a pro, it's not gonna matter much.
@34dawgsgo
Жыл бұрын
I've learned different makers use different methods to achieve the same results. I'm a hobby club builder. Place my club in the puller (graphite or steel) before applying the heat. White-painted wood heads are the devil.
Пікірлер: 15