Thanks for the video!!! How did you align the machine head with respect to the column? Txs
@pankulfon6067
6 жыл бұрын
Mateus Santana you would need a precision ground 90 degree angle plate clamped to the table and a dial test indicator mounted in the chuck, then you feed the quill up and down while the indicator is running on the plate and adjust until the reading is as close to zero movement as possible. Alternatively you could mount the dti on an articulating arm and run it on the column instead.
@dk.wgd.3207
3 жыл бұрын
Sehr informativ ! 👍
@mrpiotr231
8 жыл бұрын
Great video, is this collet chuck for BFW40/e has really that big runout? I wanted to buy it, but now I don' t know wheter KRESS spindle would be a better choice. The second thing, do you recommend that Proxxon BFB2000 drill stand and KT150 compound table? Thank you. Sorry for that google translation in advice: グレートビデオ、BFW40/ Eについては、このコレットチャックは、その大きな振れ本当にいるのですか?私はそれを購入したいが、今はKRESSスピンドルがより良い選択となるwheter'tは知っているドン。 2つ目は、あなたがそのPROXXON BFB2000ドリルスタンドとKT150化合物テーブルをお勧めですか? ありがとうございました。
@Zerohito_HILEN
8 жыл бұрын
Thank you for your comment. I don't know because there is no thing KRESS spindle using. However, I think that it is all right combination of Proxxon of genuine.
@mrpiotr231
8 жыл бұрын
Thanks ;)
@pankulfon6067
6 жыл бұрын
0.1 mm is equal to thickness of standard sheet of printer paper, not really that bad and you can compensate for it by taking smaller cuts.
Пікірлер: 26