Once you engage the eoc you wont need to manually increase your rpms. Whenever you move a boom function on turn on pump it will do it automatically.
@hulusiispir937
8 ай бұрын
Kolay gelsin turkce anlatim yapsaniz
@jumaniaccessories6538
Жыл бұрын
Hi
@samirbriseno4052
Жыл бұрын
Where can I find the Manuel for that control ? I contacted putzmeister but he can’t resolve that for me
@MrAkash-wd1zc
3 жыл бұрын
Superb ❤️❤️❤️
@juanfranciscoramirez5484
2 жыл бұрын
Esta chingon pero la antena no se consigue de ese control se tiene dos años solicitandola y que no hay
@charlesbang
2 жыл бұрын
WOW, I can't tell you anything about your problem. You'd better contact PM directly.
@Campol09
3 жыл бұрын
Whats poh stands for ?
@charlesbang
2 жыл бұрын
Push Over Head. But it can reduce the air gap in the concrete delivery pipe.
@ramkabirchaudhary
2 жыл бұрын
Sir how to make remote my remote is not working my pump remote is signal problem
@charlesbang
2 жыл бұрын
What is your remote controller model?
@ramkabirchaudhary
2 жыл бұрын
@@charlesbang same model sir
@charlesbang
2 жыл бұрын
Check the CANMAN module in the receiver. There are 6 LEDs in front of the board. The radio system is ready for operation when the LEDs 1~3 flash and LED 4 is illuminated.
@charlesbang
2 жыл бұрын
@@ramkabirchaudhary LED 1 : TOK A (yellow) lights up briefly when decoder A has successfully checked a telegram. LED 2 TOK B (yellow) lights up briefly when decoder B has successfully checked a telegram. LED 3 TOK C (yellow) lights up briefly when the CANMAN controller has successfully checked a telegram. LED 4 illuminates (green) when the receiver is ready for operation. LED 5 illuminates (yellow) when the receiver is in configuration mode (e.g. when changed values are saved using the "Enter" button). LED 6 illuminates (red) when there is an error in the CANMAN module, the emergency stop circuit or in the receiver.
Пікірлер: 17