Hi one of my battery is Indicating a red light on ALM. How can I resolve it
@dave20thmay
Жыл бұрын
Been fitting my new US5000 today and was wondering as the short leads are a bit too short, whether you can go straight across rather than diagonal as you have the 2nd and 3rd orange leads. I assume it makes no difference. When I got it all wired up I had one of the original batteries flashing the red light. So disconnected the new battery and put everything back to original and still not working, said no AC input and I found the plug labeled GRID was not properly screwed into the Control box. The retaining ring has a bayonet fitting and could never have been properly fitted by the installers and lifting a 40kg battery, must have shaken the fitting loose.
@MrJmack46
7 ай бұрын
Help I have acquired 3 Sonnen brand batteries that are Pylontech batteries. They come on for 10 minutes then shut off. I have hooked to them using RS232, I type “help” to get all the commands for getting info and a little control of the battery. What command I need is how to turn the batteries on permanently. Can you help?
@pylontechsolarbatterystora3979
7 ай бұрын
Sorry we only connect using CAN bus. We do not use RS232 , so really cannot tell you how to achieve the batteries permanent ON status but I am sure you have misconnected the batteries somewhere. Best to contact your inverter supplier or where you got the batteries from!
@MrJmack46
7 ай бұрын
@@pylontechsolarbatterystora3979 I am studying CAN bus right now. I know every communication protocol except that one. Seems like I will need a piece of hardware for my computer or Raspberry Pi, whichever I decide to communicate with the batteries. At least I now know to stop looking on the RS232 port, it provides useful information but does no control. Thanks for the reply.
@WalkabletunaVEVO
7 ай бұрын
Ive just added a us5000 to my system, 3 x us2000 1 x us3000c, i have a lux hybrid inverter which needed a modified can connector when I installed the us3000c as the master, but now im having the us5000 as the master, ive had to make another different one, is this common among different brand inverters?
@pylontechsolarbatterystora3979
7 ай бұрын
Yes different brand inverters adopt different CAN standards . As you have modified can cable then it will work
@WalkabletunaVEVO
7 ай бұрын
Just thought it was odd, I had to modify the cable for the different model batteries from the same manufacturer, yet there is very little if any info on this, very strange
@pylontechsolarbatterystora3979
7 ай бұрын
Very little info and not all manufacturers share a set standard. Its a shame really but its the way things are. Please subscibe to this channel. @@WalkabletunaVEVO
@WalkabletunaVEVO
7 ай бұрын
Already subscribed 👍
@WalkabletunaVEVO
7 ай бұрын
Unfortunately having an issue with my lux inverter, the DC side seems to have gone kaput, batteries aren't charging/discharging and no solar production is happening, my installer is looking into it but just keep going round in circles 😢
@Pvaleriy
Жыл бұрын
I am also interested in how to turn on the master and slave dip switches
@pylontechsolarbatterystora3979
Жыл бұрын
You only need to set dip switch address if using rs485 communication protocol
Пікірлер: 16