sorry boys after checking further only the piston pivot point is higher in bore ? my first impression was wrong ?
@grahamherbert3612
Жыл бұрын
CST 11 expansion, Is still the best pipe for a Quattrini build. An outstanding kit.
@paulstephans3364
4 жыл бұрын
I have long range tank so no airbox and widened the exhaust port on the barrel nice one.
@gmar1942
4 жыл бұрын
Great review...explained a lot which I didn't realise..Thanks..
@CarlEves
4 жыл бұрын
Cheers. Looking at getting one of these to replace my Imola. Still undecided though 🤔🤔
@chrisknight3847
4 жыл бұрын
Excellent, keep up the good work
@kickbackgarage
4 жыл бұрын
Chiselspeed make a inlett assy in alu, and you can then use a standard mikuni rubber. £50 but come in fancy colours. :)
@TheSteelweasel
4 жыл бұрын
cheers bro ✌
@kickbackgarage
4 жыл бұрын
@@TheSteelweasel Is this going back or are you going to give it a go? Chiselspeed also make a nice pipe for them. The cylinder looks well made.
@TheSteelweasel
4 жыл бұрын
@@kickbackgarage nope ive only got it to make an exhaust jig 😉
@paulstephans3364
4 жыл бұрын
Hi weasel after a bit off advicewhen you done the transfer work on the casa 185 kit a while ago what card do you recommend for this I have a 50mm gori exhaust cheers buddy keep up the wicked videos cheers 👍
@TheSteelweasel
4 жыл бұрын
28 MM PWK ARE GOOD MATE . cost you about 40 quid on ebay + 15 for a cable choke kit
@paulstephans3364
4 жыл бұрын
Cheers weasel
@MassDebate67
4 жыл бұрын
What Mods do you need for a Spanish Block to fit a Quatrini 210 (welding etc)
@TheSteelweasel
4 жыл бұрын
the only issue i found was the piston rings drop in to the inlet port and its tricky to push them down . but spanish casing are the best lots of meat around the transfere ports .....
@marcushalls4648
Жыл бұрын
What would be my best crankshaft for this kit any advice on maximum power thanks
@TheSteelweasel
Жыл бұрын
Off the shelf SIP race with 116 rod . A friend of mine has dyno his at 35 bhp with a hand made pipe and some tuning no bad .
Пікірлер: 17