Hi. I already hv tpa3116 100w x 2 amplifier. Is this an upgrade? No noise? How d Sound quality and power?
@winyanmaew
Жыл бұрын
Hi, if you want to upgrade from the 200W amp, I recommend upgrading to the 600W IC TPA3255 as the 1602T is a good amp. no noise But the sound quality I think is not good. because there is a low soundstage and too much bass. 600W 2.0CH IC TPA3255 kzitem.info/news/bejne/lZ144KekrJiIZ4Y
@truckman7123
Жыл бұрын
@วิญญาณแมว thks. I hv fosi bluetooth tpa3255. Very Good sound quality but driving 8ohm big speakers in big room, volume is a bit soft. Thks again.
@อภิชัยแสนองอาจ
3 ай бұрын
ใช้ผ่านมือถือทำยังไงคับ😊
@winyanmaew
3 ай бұрын
สามารถต่อบลูทูธเข้าแอมป์ได้เลยครับ หรืออยากต่อสายก็สามารถผ่าน Aux ได้
How about connection to mic amp ? What pin number? ❤
@winyanmaew
3 ай бұрын
The RL signal bypass point to connect to a preamp or Bluetooth is C10 / C11.
@จิระวัฒน์ล้ําจุมจัง
2 ай бұрын
ผมได้มาไม่เหมือนในคลิปเลยค้าบ สงสัยได้ของปลอม
@winyanmaew
2 ай бұрын
ท่านได้มามีส่วนไหนที่ไม่เหมือนครับ
@จิระวัฒน์ล้ําจุมจัง
2 ай бұрын
@@winyanmaew ชื่อบลูทูธ เลขบนเพลก็ไม่มีค้าบ
@ramiesarsalejo9547
3 ай бұрын
please ask me sir beautiful zk 1602t compare zk xpsm? how to connect for mic amp or zk amp? I hope you reply me. thank you ❤❤❤
@winyanmaew
3 ай бұрын
zk-1602's circuit is better than zk-xpsm, but both of them I don't recommend because the sound is too warm and the stage is too narrow. I recommend zk-3002t because it's the best 2.0ch amp under 30usd budget. In addition, the zk-3002t has a mic pre-connection point. So it's easy to upgrade.
Пікірлер: 148