Ed when pressing back in you want to push on outer race not inner. it will flat spot them
@MrUCL
6 жыл бұрын
Ed what brand of bearing is that I have never seen white ceramic bearings.
@silden11
6 жыл бұрын
These are the new full ceramic bearings from R1. you have to be careful while installing them, ceramic doesn’t like any miss alignment or it will disintegrate.
@silden11
6 жыл бұрын
The tool should only press on the outer race to minimize the force put on to the ceramic balls.
@EdwardPickering
6 жыл бұрын
This can be easily changed by using a washer that is a slightly larger diameter.
@dwparker14
6 жыл бұрын
Are you going to do a review on the bearings?
@EdwardPickering
6 жыл бұрын
I could ;)
@dwparker14
6 жыл бұрын
Thanks!!!! Really want to know if they are worth the small fortune.
@stu661
6 жыл бұрын
Interesting little tool. I don't think I would be keen on pressing a new bearing in by just pressing on the inner race. It would be far better if the tool pressed on the inner and outer race
@silden11
6 жыл бұрын
The tool should only press on the outer race to minimize the force put on to the ceramic balls.
@EdwardPickering
6 жыл бұрын
This can be easily changed by using a washer that is a slightly larger diameter.
Пікірлер: 11