1000 C (1832 F) Electrical Kiln + Quartz Window: Programmable
Technical Supermarket (London)
Another worthy addition to the workshop.
Hopefully to be used for silver soldering Nickel wires to ceramic elements without risking cracking the elements as often happens with Oxy/Ace gear despite using a micro torch.
I would fit some silicon feet to this or strips of rubber or similar to avoid scratching the worksurface. At higher temperatures it may be necessary to put the kiln on a heat proof tiled surface.
On arrival I suggest removing the cover to the electronics, thanks for the tip Kev, and tighten all the terminals as required. The SSR terminals were loose on mine.
Make sure the factory first use heating program is run before you use this at high temperatures. That is 100 degs C for 10 minutes. run that if the kiln hasn't been used for a while as well.
A filtering fume chimney is available for this model as is a replacement element.
The kiln
kilnsandaccess...
The filter chimney
kilnsandaccess...
The element
kilnsandaccess...
Other spares like the SSR are available.
Негізгі бет R14-UP Programmable 1000 degs C Kiln
Пікірлер: 3