how did you figure out the needed CLI lines? i was stuck trying to get it to work with the rx on fport until i saw your video... thanks!
@nfavor
3 ай бұрын
I appreciate the video but made the jump to ELRS with the FlyDragon F722 (competes with the RM Nexus). Getting rid of the external satellite of any kind was a nice bonus for me. Rangers aren't that expensive either. I'm sure a future Nexus will have internal ELRS like the FlyDragon already does.
@RCVideoReviews
3 ай бұрын
I was a little surprised they released the Nexus sans internal ELRS, but I guess it leaves the door open to all RF tech without incurring the extra $20 cost. I kinda hope they release an all-in-one too.
@peterhancox5268
3 ай бұрын
Just bought a Boxer with EdgeTX. Upgrading from Taranis X9D OpenTX. Is your video on converting by going back to Edge 2.8 to convert still valid? Thanks
@RCVideoReviews
3 ай бұрын
Yes. You can no longer go from OpenTX to the latest version of EdgeTX without stopping on 2.8 first. After 2.8, EdgeTX no longer reads and converts binary files to YML format. kzitem.info/news/bejne/r4-YtYCCqIheenY
@peterhancox5268
3 ай бұрын
@@RCVideoReviews Thanks, but this does not work on a Boxer. I cannot flash the 2.8.4 firmware by pressing the jog wheel, nothing happens. My new Boxer was shipped with Edge 2.9. My old TX is a Taranis X9+ and I'm hoping to shift my models setup from the Taranis to the Boxer then flash the Boxer with the latest Edge. Any clues? Thanks
@marinehm
3 ай бұрын
Obviously, this does not apply to ELRS? Right?
@RCVideoReviews
3 ай бұрын
No. ELRS is 2 wire full duplex and a different protocol.
Пікірлер: 10