Thank you! I have do this exact job and this is brilliantly helpful!
@johnelbro127
Жыл бұрын
Very educational and professional. Cheers good video. 👍👍👍👍👍👍
@donboyfisher
Жыл бұрын
Nice vid. The EPB actuator works a rod that pushes on the inside rear of the caliper piston. Its touch contact, so pushes only against the piston. When it retracts, it just pulls away from the back of the piston face, it doesn’t actually put any ‘pull’ force on the piston to retract it.
@ianwarriner8193
Жыл бұрын
Thanks for the explanation , but couldn't get my offside piston to go back in , even with the epb in service condition😮
@earlepeacock8315
5 ай бұрын
I think you will find your electronic service tool requires you to press the button to turn the parking brake off before attempting to do it with the tool, That's the way it works on my iCarSoft tool (took me a while to figure out that what was causing the failed error message). Hope that helps...
@09proudvet
5 ай бұрын
What about bleeding the system afterwards, and is there a sensor reset that has to happen?
@RaymiesGarage
5 ай бұрын
no need to bleed the brakes when replacing pads and discs
@petzbuzz2825
Жыл бұрын
Many thanks great video, although i wish i came across this video before i tried to replace myself. Didn't remove the connector before removing the calibre and pads and then the EPB self activated and pushed out the piston fully ! Doh ! Managed to get the piston re-engage and pushed back just enough to get new pads back and brakes seem to working properly but now a warning notification keeps coming up "Park Brake Requires Calibration Apply Foot and Park Brake" any recommendation on how to fix/reset ?
@user-cq9oy4xc9w
6 ай бұрын
Hi I have 2016 autobiography can I do the same like the your video or not ??? Thank you
@RaymiesGarage
6 ай бұрын
yes sure give it a go,
@user-cq9oy4xc9w
6 ай бұрын
Is not work
@user-cq9oy4xc9w
6 ай бұрын
Thanks
@firatyaman7789
Жыл бұрын
It's a nice video, detailed explanation, but I noticed something, there is a lot of rust under these models, is this normal? Or is it too humid where you live?😮
@RaymiesGarage
Жыл бұрын
I live in Scotland thats should explain it lol
@firatyaman7789
Жыл бұрын
@@RaymiesGarage I understand, so the sun is less, the rain is cold, this situation causes it to rot quickly, thank you
@josephgittos3787
Жыл бұрын
Did you not have a wear sensor on the brake brakes , mines come up with brakes worn on the dash , looked at the brakes and still some meat left on them but for a couple of weeks it’s still says brake pads worn how to get rid of this message
@RaymiesGarage
Жыл бұрын
Possibily the sensor is not functioning correctly
@whiskywhippet
Жыл бұрын
What TX size was the disk retaining bolt please? PS very handy video thanks.
@RaymiesGarage
Жыл бұрын
Think it was T30 if I remember correctly
@whiskywhippet
Жыл бұрын
Job went well thanks, turned out the disk TX bolt was TX50.
@icloudphotos1537
Жыл бұрын
Hi , is the rust normal? 😢I’m about to buy a second hand evoque, I’m not sure about the rust on the brake pads .
@RaymiesGarage
Жыл бұрын
here in Scotland yes rust is normal
@jerrygreene7139
Жыл бұрын
Curious what a ballpark estimate of the cost to redo pads and discs on all 4 wheels parts and labor. Thanks for the video!
@jerrygreene7139
Жыл бұрын
Sorry, I’m sure it depends on the vehicle. I have a 2011 HSE L322.
@RaymiesGarage
Жыл бұрын
Getting it done at a garage around £450 - £500, doing it yourself parts only £220
@martinthompson4202
Жыл бұрын
I've been quoted £450 for all 4 to be done on a 2013 RR Evoque, given the time and tools needed to do it, It's not a bad price for all 4
@robertwymark6811
Жыл бұрын
Great video. Once I'm done do I just start the car and put the hand brake back on or is there a special way to do it. Thanks.
@RaymiesGarage
Жыл бұрын
In the car press and hold down the accelerator (keep it down) Whilst holding the parking brake switch up (in the engage position) switch the ignition on, off then on. This will put the parking bake actuator back into normal operating position. To retract the parking brake actuator, do the same as above only hold the parking brake switch in the off position
@robertwymark1102
Жыл бұрын
@RaymiesGarage thanks a lot that's brilliant
@robames4
Жыл бұрын
How did you get the electric brake to go back on . Is this simply just plug back in . Or do you have to do from the car
@RaymiesGarage
Жыл бұрын
Just plug in
@robames4
Жыл бұрын
Thank you
@iTsTHumpa
Жыл бұрын
Does the rear brake pad wear sensor need to be replaced with pads?
@RaymiesGarage
Жыл бұрын
its good practice to replace the sensor , however if its not damaged you could re use it
Пікірлер: 34