Trying to further improve the optical train and OTA output, by installing a 3DPrinted Flocked sleeve into the optical train, and also flocking the internal of the Rasa 11" telescope.
A challenging but fun project and think has seen an improvement on initial test done.
For the mods;
The 3D Printed sleeve was printed using Bambu Lab PLA-CF Filament
The paint used was the Musou Black and the flocking fabric was the glued backing IR Flock material, both sourced from the MusouBlack website.
I had been putting this off for months, had actually ordered the material in July 2023 and only just got round to tackling this now in June 2024! Took a long time to commit to tackling this!
Clear skies!
----------------------------------------------------------------------------------------------------------
I upload my images to Telescopius, and you can find my profile at:
telescopius.co...
My other social locations are;
www.daves-astr...
/ daves.astrophotography
/ daveauld
/ dave_auld
The main equipment I use is;
Celestron CGX mount
Celestron CGX-L mount
Celestron Edge 11
Celestron RASA 11
Lunt LS80MTB1800C Solar Scope
Bresser 8" Newtonian
Bresser AR90s/500
ZWO ASI2600MC-P Colour cameras
ZWO 60/280 guidescope
ZWO ASI120mm guide camera
ZWO ASI174mini guide camera
ZWO ASI174mm planetary camera
Unihedron Sky Quality Meter (SQM)
NexDome Observatory
#Astrophotography #DavesAstrophotography #Cyprus
Негізгі бет Rasa 11" - Sleeving Optics and Flocking OTA
Пікірлер: 22