As an HVAC contractor I said you did excellent job better the most contractors out there . People sometimes want to be smart ass with all those questions and I bet you they don’t do what they supposed to do great job . I rated you 10/10
@ApartmentMaintenancePro
Жыл бұрын
Appreciate it! Thanks for watching 😀
@mrtrenz
Жыл бұрын
Evening from Aurora, CO...thanks for another great video...10
@ApartmentMaintenancePro
Жыл бұрын
Hey thanks for watching neighbor!!
@taylorstapp5855
11 ай бұрын
10/10. Excellent work should last for years. Only complaint is I didn't hear "aw yeah its coolin" at the end. Kinda the equivalent of "that aint goin nowhere" when you strap down that couch in the back of the truck. 😂😂😂
@ApartmentMaintenancePro
11 ай бұрын
haha will be sure to input that next repair :)
@douglaswatters7303
Жыл бұрын
Thank you for not killing that spider. I give this install a 11 on a scale of one to ten. (Spinal Tap is a great movie)
@ApartmentMaintenancePro
11 ай бұрын
Thank you! Love the spiders :)
@salehabdullah399
Жыл бұрын
10
@juntang72
11 ай бұрын
Nice and clean work with professionalism. Cheers!
@ApartmentMaintenancePro
11 ай бұрын
Thanks
@phoenixhvac-r828
Жыл бұрын
Very well done, that's a 10, in fact you should be on the cover of the spring-summer edition of USAirconditioning magazine.
@ApartmentMaintenancePro
Жыл бұрын
Dang thanks 🙏 😊
@octaviofigueroafigueroa9794
Жыл бұрын
Hello. I think your soldering skills have inproved a lot! In you past videos I saw that you used to high temperatures and the pipes become red at almost to a melting point. Congratulations!👏👏
@ApartmentMaintenancePro
Жыл бұрын
Hey I appreciate that! one thing I finally did was buy my own torch set so I am used to how it works now :)
@octaviofigueroafigueroa9794
Жыл бұрын
👏👏👏👏
@marcelofrias7618
Жыл бұрын
Great job 👏
@ApartmentMaintenancePro
Жыл бұрын
Thank you 🙏
@samyz1660
Жыл бұрын
Excellent work. Pro .
@ApartmentMaintenancePro
Жыл бұрын
Thanks a lot! ⚒️⚒️⚒️
@T-Bone-nk1ng
Жыл бұрын
At least they didn't pull a Daikin and stuff the filter drier on the ground inside the condenser. Even on their big ones they do that. Just gotta hope you can fit inside the thing lol.
@joseirizarry801
Жыл бұрын
Nice!!! 10
@ApartmentMaintenancePro
Жыл бұрын
Thank you!
@jamminwrenches860
Жыл бұрын
Good work. 10 out of 10. I may have poured the old compressor oil out just to see how much is in the system.
@ApartmentMaintenancePro
Жыл бұрын
Thanks jammin!!
@sheldon8115
Жыл бұрын
So far very good 👍
@ApartmentMaintenancePro
Жыл бұрын
Thank you 🙏
@brianbray5397
Жыл бұрын
Compressor install is fine, I can't get over all the sealtite. What kind of inspectors do you have? Absentia?
@jstmyers
Жыл бұрын
Nice!!!!
@ApartmentMaintenancePro
Жыл бұрын
Thanks! 👍
@user-dy6on2ue4e
Жыл бұрын
What pressures are you setting up your oxy ace ? I Always have hard time to braze on the bottom of the compressor, good job flowing nitrogen too, keep up!
@ApartmentMaintenancePro
Жыл бұрын
10 oxy 5 ace 👍
@AaronPowellvox
Жыл бұрын
1 point deducted for not reaming the copper. (Or not showing it) I’d give you a 9 out of 10. Great work bro!
@ApartmentMaintenancePro
Жыл бұрын
ahh yes thank you! forgot about that
@Jason-wc3fh
Жыл бұрын
So he could get copper shavings in the line to plug things and cause damage? Screw that
@AaronPowellvox
Жыл бұрын
@@Jason-wc3fh lol. There is a way to do it without getting shavings in the system. It takes practice and experience though. I’m sure he knows how. He’s good at everything.
@bobbywanger8123
Жыл бұрын
👍🔥🍦🍦🍦
@ApartmentMaintenancePro
Жыл бұрын
🙏
@allenlane5000
Жыл бұрын
what is the cost difference on replacing compressor vs. the entire outside unit?
@ApartmentMaintenancePro
Жыл бұрын
Couple hundred dollars with refrigerant on this unit.
@FrenchBeefCDN
11 ай бұрын
There are nitpicks you could do different but I 100% bet the factory did a sloppier job than you. 10/10 because I didn’t have to do it.
@ApartmentMaintenancePro
11 ай бұрын
Appreciate that :)
@Jason-wc3fh
Жыл бұрын
I'd give a 10 but had to drop to a 9.5 because I saw part of the sticker get a tad heated up when you were brazing the filter dryer. I always like to see the schematics diagram in mint condition when I have to service equipment. If that's the only thing I can really complain about, you must be doing something right.
@ApartmentMaintenancePro
Жыл бұрын
I hear ya, thanks for the reply 😀
@benjamintimmins1656
Жыл бұрын
Did you charge the system while schraders were out, THEN put the cores back in or no? Id give you 9 out of 10. Good job!
@ApartmentMaintenancePro
Жыл бұрын
I believe here I broke vacuum and weighed in the charge with the shraeders out as its much faster without them in. Then charged the system with them in 👍 Thanks for watching and I'll gladly take a 9
@benjamintimmins1656
Жыл бұрын
@ApartmentMaintenancePro ok good. I was gonna say if you put schraders in before adding charge you would of lost your vacuum. Good practices all around. I like how you cut the copper instead of sweating out. 10 out of 10!
@abdullah_q8171
11 ай бұрын
No need to clean the circle with nitrogen ?
@ApartmentMaintenancePro
11 ай бұрын
I purged nitrogen
@EverythingHVACR
Жыл бұрын
Gonna have to change your name to HVAC maintenance pro!
@ApartmentMaintenancePro
Жыл бұрын
⚒️⚒️ has a nice ring to it lol there are some really good pros out there need a lot more experience to reach their level
@EverythingHVACR
Жыл бұрын
@ApartmentMaintenancePro just keep reaching! Real pros never stop learning at any level.
@jimmydavis6846
Жыл бұрын
just use stay-brite 8 and propane,,,alot easier and no carbon residue in your lines,,
@ApartmentMaintenancePro
Жыл бұрын
NEVER
@Dan-ger82
Жыл бұрын
Surprised your an apartment maintenance person doing this. Most maintenance guys I've met can barely troubleshoot a bad capacitor let alone a faulty compressor. I used to unsweat the compressor but it's better to start with new copper. Actually flowing nitrogen also means you're better than most out there. I take it you've got EPA license for refrigerant. I would say you're definitely a deal to some apartment complex if your working for them instead of an AC company.
@ApartmentMaintenancePro
Жыл бұрын
Thanks Dan ! I've worked for an HVAC company before many years ago 👍
@Dan-ger82
Жыл бұрын
@@ApartmentMaintenancePro yeah I did AC also. But in Florida it got too much to climb in attics. Some customers could care less about your safety and health if they have to live a day without AC so I left the field. An old neighbor of ours even had the nerve to come ask if my dad could fix her AC when he was on hospice. When we told her he was currently in our living room days away from dying she asked if I could come fix it instead. Unbelievable.
@ApartmentMaintenancePro
Жыл бұрын
@@Dan-ger82 ya I lived in florida doing ac, servicing the Naples FL area, I'm all to familiar with 140 degree attics swapping out evap coils all day. Some snotty people down in those parts
@Dan-ger82
Жыл бұрын
@@ApartmentMaintenancePro I'm on opposite coast by Palm Beach. It's definitely not the natives that ruining this state. I'm ready to leave but stuck due to family.
Пікірлер: 60