Heng long should do this one modification on ALL their tanks. My new KV-2 7.0 is throwing the tracks because of excessive play at the axle. So i spent $312.00 for a nice looking tank that i cant run. Its hard to figure out ,( for me) if this universal DAS will work . 😢
@last_name3143
3 жыл бұрын
Hey Stan, I have some left over aluminium stock for my lathe and some 8mm bearings. I was hoping to turn up some shaft support bearings to fit the Heng Long Abrams. Would you be able to provide the external dimensions for that part? If not no worries. Cheers from Australia
@StanlleyLegion
3 жыл бұрын
it's easy enough, just measure and find out what you need ;)
@jeffrenman4146
2 жыл бұрын
your website shows that you have a set for the bulldog tank…does it fit over top of the original plastic without any modifications?… And then just add the bolts? I hope you see me and thank you
@StanlleyLegion
2 жыл бұрын
i don't have for Bulldog, sorry!
@ghosttjr2
6 жыл бұрын
I did this yesterday on my Tiger with steel gearboxes, I use the brass ones
@andrewwillard5625
3 жыл бұрын
Where do I get this I desperately need this
@StanlleyLegion
3 жыл бұрын
www.rctanklegion.com/search?q=das
@seung-hoonyeon9682
5 жыл бұрын
Hiw do u remove the hub? Is there any special method to remove cleanly
@StanlleyLegion
5 жыл бұрын
What tank?
@seung-hoonyeon9682
5 жыл бұрын
@@StanlleyLegion king tiger. I completed my order on your site. when do u think it will arrive?
@StanlleyLegion
5 жыл бұрын
I used a needle nose plier to open the hub cap. Then use an Allen key (2.5mm) to open the cap screw bolt. The "final drive" cover needs to be pried off
@StanlleyLegion
5 жыл бұрын
we can only ship after CNY- all shipping stopped already. (we tried today but nothing is working) sorry
@rileydagg7387
6 жыл бұрын
Do you have any that would fit, or work on the Walker Bulldog heng long??
@StanlleyLegion
6 жыл бұрын
riley Dagg I think the universal DAS should be able to fit. I will test it tomorrow
@rileydagg7387
6 жыл бұрын
Could you plz... thanks
@rileydagg7387
6 жыл бұрын
Legion Products Stanlley any luck yet??
@StanlleyLegion
6 жыл бұрын
pardon for the late reply- negative, the design of the lower hull doesn't allow this, unless you cut the original hull protusion, flush. Anything possible if you want
@tollaslaci2094
4 жыл бұрын
Hello, Can the rear rollers be made of ball bearings? Thanks in advance!
@StanlleyLegion
4 жыл бұрын
you mean the upper track rollers?
@tollaslaci2094
4 жыл бұрын
Stanlley Legion hello, yes for the top roller. I have 1 tiger tank.
Пікірлер: 24