Hey everyone, this is part one of a series where I'm repairing and restoring this vintage RCA 16x3 vacuum tube antique radio from 1940. It's in near pristine mint conidition, save for a few scratches, and the fact it doesn't actually work. Yet.
Let me apologize up front for the total crap quality of most of the video. While I was editing, I ACCIDENTALLY THE FILES and all I had left was a few of Adobe Premiere's proxy files to work with. I'll be more careful next time, promise.
As you can see, I run into a few problems, the biggest of which is the existence of pre-war rotten rubber wiring. ack.
I'd appreciate any feedback you can give, good or bad as long as its constructive.
I'll set up chapters later, but let's get right to it. or something.
---
Be sure to check out the website and I'm on the big social networks, except that one that used to be a bird. I mean technically I am, but....meh.
ripptech.com/
/ ripptechlabs
/ ripptechlabs
[ / @ripptechlabs
/ ripptech
I’m streaming LIVE on Twitch and KZitem on no particular schedule at the moment, so there's that. Be sure and stick around til the end for kittens. 😺
My equipment is outdated by years, but if you're interested:
(Affiliate links: If you purchase from Amazon after following these links, I will receive a small commission at no additional cost to you.)
Camera 1: Panasonic HC-X920 amzn.to/44geFeD
Camera 2: Canon VIXIA R400 amzn.to/3Pnz1xf
Shotgun Mic: Rode VideoMic: amzn.to/3LnSyMJ
Denali by SKIL 4V: amzn.to/3t1FTsh
YIHUA 959D amzn.to/3sT5vrs
Hakko FX888-23BY amzn.to/45Rnc9y
#fixit #electronics #repair #soldering #retro #vintage #antique
Негізгі бет RCA 16x3 Vintage Radio Restore Pt 1
Пікірлер: 14