Needle position on the cop can make hole on the top of piston
@stevenedwards2162
8 ай бұрын
I have a yds7 runs idles and rides great, but I have to turn the fuel tap to stop position every time I stop as the carbs will fill and overflow, even got into the exhausts, and will never start with a kick I've had to bump start her down a long hill, what would you think would be the most likely cause for this problem.
@jh-tech5546
8 ай бұрын
As you explain I would think the float needles are the issue. You might have to check them.
@anandsaig5259
3 жыл бұрын
Beautiful Video Mate . Are those carb Hose clamps the same size front and back ?
@jh-tech5546
3 жыл бұрын
No, I don't think so.
@paullynch2159
3 жыл бұрын
Very good,, how are you with the electrics on these bikes, iv checked out the loom diagram but can't make any sense of it , keep up the good work 👍🏻
@jh-tech5546
3 жыл бұрын
Thanks. I was lucky, all electrics on the bike are in good condition and work fine.
@peterharding5959
Жыл бұрын
HOW DID U SET FLOAT LEVEL I SEE USING A VERNIER BUT COULD NOT SE WHAT U USED AS REFERNACE
@jh-tech5546
11 ай бұрын
Hi, sorry for the late answer. I usually measure between the gasket surface and the top of the float. Notice the spring in the needle should not be compressed.
@juanspolzinogomez5588
3 жыл бұрын
Amigo donde puedo conseguir los accesorios que lleva el carburador
Пікірлер: 14