You are an absolute life saver. Thank you i was about to have panic attack!
@takapunaika2089
Жыл бұрын
I'm wondering how we can we bypass the power box to only control one motor only?
@danielllope8783
2 жыл бұрын
YOOOOOO I had little faith this would work but it did! I thought I was going to have to get in there with a toolbox but nope! Back to normal. Thanks!
@uknowngamer8852
4 жыл бұрын
OMG thank you so much it worked for me 1st time just after I spent an hour fiddling around with the cables with no joy!
@rajinihinduja
2 жыл бұрын
This video was a life saver. Wish there was audio - but i was able to watch it and figure out what was wrong with my standing desk. - the little white plastic parts that ajoin around the silver bar/rod that rotates were not connected anymore. presto - voila!
@rozabokin53
Жыл бұрын
lo hiciste tu solo, o viste algún video, te agradecería enormemente si me ayudas, mi base tampoco ya quiere subir, y pareciera como si hubiera bajado de mas.
@omaralmashhadani4923
Жыл бұрын
Thank you, saved me
@benjaminb5889
2 жыл бұрын
thank you for your video
@bukchoiii
4 жыл бұрын
worked for my desk, thankssss!
@4R2R4
Жыл бұрын
THANKS FO MUCH
@peterfav117577
3 жыл бұрын
My desk only raising a little and I keep resetting it ,but it's not working.
@Filmbz
3 жыл бұрын
Thank you for sharing this great info. I'm trying to figure out what can be done when we continually receive the E09 error after holding down and the table makes that final readjustment upwards. It seems like it gets stuck on the way up every time.
@albertosierra9787
2 жыл бұрын
Same issue here. Did you finally fixed it?
@Filmbz
2 жыл бұрын
@@albertosierra9787 i did figure it out.... I made sure each leg worked individually and i believe it was the power chord
@albertosierra9787
2 жыл бұрын
@@Filmbz so changing the power chord worked for you?
@Filmbz
2 жыл бұрын
@@albertosierra9787 the company sent a warranty replacement
@Filmbz
2 жыл бұрын
@@albertosierra9787 yes, I was using an old chord for one leg which was the culprit
@hiskishow
6 жыл бұрын
OMG thank you so much!!
@deediegraphiti
2 жыл бұрын
this is not working for me. When i plug it back in, the display just reads CAL and no buttons produce any affect besides holding M which locks and unlocks. The arrows do not cause any response no matter how long they have been held down after power cycling.
@bedtimeredit6283
2 жыл бұрын
Same idk what to do
@AmauryQuintero
2 жыл бұрын
Hello can you tell me where I can buy the control button? I have a TC15-L control box but I don't have the correct button for making it up and down, thanks!!
Пікірлер: 23