Reading Erasing and Resetting Malfunction codes stored in ECU in HONDA motorcycles by check engine light note down
Resetting throttle plate angle sensor using a jumper wire!!
There are 8 sensors in karizma ZMR ,,9 in new model...
1 Throttle angle sensor
2 Air intake temp sensor
3 Mass air flow sensor
4 Oil temp sensor
5 Oxygen sensor(o2)
6 Crank angle sensor(ignition and fuel injection timing)
7 Bank angle sensor
8 Speed sensor
9 Side stand sensor(optional)
In case of any doubt feel free to comment below on how to check and erase code regarding any sensor..
Karizma Zmr engine check light blinks...
1 blink=MAF sensor
7 blinks=Oil temp sensor
8 blinks= Throttle angle sensor
9 blinks= Air intake temp sensor
12 blinks=Injector malfunction(1 Long nd 2 short)
21 blinks=o2 sensor
29 blinks=Idle air control valve malfunction(2 long 9 short)
54 Blinks=Bank Angle sensor malfunction(5 long 4 short)
Continuous = data link connector or PGM FI malfunction
1,8 blinks=sensor unit power malfunction
1,8,9 blinks=sensor unit ground malfunction
1 Long blink=10 blinks
1 short blink = 1 blink
So for 12 blinks it's gonna give 1 long and 2 short blinks!!!!
Make sure to reset Throttle sensor once pulled out!!!!
Do Subscribe for more..!!!
Email:- powerpulse.remapping@gmail.com
Follow me on Instagram= / tony.blaze009
Негізгі бет Reading and Resetting Karizma ZMR CBR 250 ECU Malfunction codes and Throttle plate angle Sensor
Пікірлер: 196