You have some nice shop! And it's quite interesting, how a little misalignment on the valve can lead to such a devastating damage.
@valeriumoscalu7580
Жыл бұрын
Thankyou! The problem wasn't in the valves, the jet ski was turned upside down in the water and when you want to roll it back you should do it clockwise but they didn't counter clockwise and the water got through the intake inside the cylinder, and they starter it with water in the cylinder and water can't be compressed like air and damaged the piston rod!
@jorbedo
10 ай бұрын
Excellent video series, thanks!
@valeriumoscalu7580
10 ай бұрын
Thank you sir! Appreciate your feedback!
@bernardmcnamara
3 ай бұрын
I ask. Why is it it seems. With the Yamaha MR-1 160hp 1100cc engine. It's the number 1 cylinder conrod that seems to brake a lot.
@asaprotrans3889
2 ай бұрын
Zdarovo u menya svho ne tyanet bolshe chem 40mph neznaesh vchem mojet bit prichina ? Pomenyal svechi nichevo ne izmenilos
@user-rh6gq6wk5c
11 ай бұрын
What if all the cylinders are moving when you turn it over?
@salvatorem740
2 жыл бұрын
This video just came in clutch
@valeriumoscalu7580
2 жыл бұрын
What do you mean?
@salvatorem740
2 жыл бұрын
Was very usual I just pulled my head off but all my pistons crank just my timing chain snapped
@salvatorem740
2 жыл бұрын
And valves bent
@salvatorem740
2 жыл бұрын
Post a part 3
@DoyleHargraves
Жыл бұрын
I have the same engine in my Yamaha fsh 190. Mine runs great. What are the weak links on these engines?
@valeriumoscalu7580
Жыл бұрын
They don't have weak points, very good engines! Valve adjustment on time and you are good to go! Mine was turned upside down and someone tried to start it with water inside the cylinder and broke the piston rod in pieces!
@DoyleHargraves
Жыл бұрын
@@valeriumoscalu7580 i run Rotella T6 5w-40 in it with a motorcraft oil filter. Is that ok?
@DoyleHargraves
Жыл бұрын
I mean, 30 hours on that oil and filter, and she runs great.
@user-iw4wv4zm6p
8 ай бұрын
Is it possible to engrave the cylinder to a larger piston size? The original is 86 mm and needs to be engraved for an 86.5 mm piston
@valeriumoscalu7580
8 ай бұрын
This is what I did, I bored 0.5 mm bigger! What car do you have? Make model year?
@user-iw4wv4zm6p
8 ай бұрын
Yamaha waveraner 2009 fzr 1800 supercharger
@valeriumoscalu7580
8 ай бұрын
Yes 0.5 should be ok! But if you can go 0.25 will be better!
Пікірлер: 23