What’s the torque specs for the head how much ft lbs torque ?
@gregorysinclair2716
2 жыл бұрын
Greetings . How do I find high quality piston rings for the wlt? Thanks
@InnocentArcticBirds-gy5ri
5 ай бұрын
And why don't start the engine while injector pump is fine and even nozzles are fine but file to start engine
@jesuschristismylord8987
2 жыл бұрын
whats the size number you adjusting your clearence 010 or 05 for inlet and exhaust
@cggmslimited5418
Жыл бұрын
10- intake and 12- exhaust
@michaelwalsh7847
Жыл бұрын
You put on that left pump cover plate wrong you didn’t line up the little Gove to the other Gove bro you got the timing right but the bump cover plate you didn’t line up right
@garygasmackenzie1301
25 күн бұрын
Taylor Deborah Johnson Sharon Garcia Eric
@ferdinandcastillejo1215
2 жыл бұрын
looks the timing plate on the injection pump is not in the correct direction?
@ToNGanKiD143
2 жыл бұрын
you are right, that hole on the bottom of the plate should be ontop , goes throuh a slot, you can see the slot on top has push the plate out.
@madibi2411
Жыл бұрын
Does the pulley mark go to the left of that cover mark ot the right side of it coz I seem to can't get it straight there
@jesuschristismylord8987
2 жыл бұрын
Very good teaching 👍
@evaneswyatt2527
Жыл бұрын
The distribution setting is not done by the tdc mark on the crankshaft pulley?
@joeyjamila7317
Жыл бұрын
hooooiy your injection pump timing cover is inverted it is not in the hole
@joaovieira9265
Жыл бұрын
A arte da mecânica da muita felicidade s
@martinquant3784
Жыл бұрын
What size is crank pulley bolt
@1010Singularity
2 жыл бұрын
Why are there 2 marks on the crank pulley?
@baazigaj9125
2 жыл бұрын
right is to dead center and the left is 10 degree after tdc
@hermanfrans9169
3 ай бұрын
🤝🤝🤝👍🙏
@philemonkalai3076
2 жыл бұрын
In stolen timing gears
@joaovieira9265
Жыл бұрын
Quero aprender
@hady7547
Жыл бұрын
Hi does the gear on the camshaft move out of place because it's the mark on the camshaft the gear is on top but the bumps are not in the right place
@madibi2411
Жыл бұрын
Greetings, did you end up getting it right? Is the sprock mark to the left or right side of the cover ? I seem to can't get it straight on the cover marl with all methods I tried
Пікірлер: 23