I know most of this, bit still watched it all, always enjoy your vids, and appreciate your knowledge 👍👍
@Kristof-1983
5 ай бұрын
Nice work again Leon!
@jwhiteker1
5 ай бұрын
Great stuff Leon. Ive learned several lessons watching your content. I really appreciate all the detail. 👊
@Ron-0417
5 ай бұрын
When you have the bar in the vice to close the gap, I would put a piece of wood (a 2x4 cut to fit), under the bar, so it can't get pounded down any further. I think hammering on the bar on the anvil part is what caused the big chip.
@glenspryszak6005
5 ай бұрын
By placing the bar rails on the vice.......you were inadvertently smashing the opposite down side.... I put the chain in the rail. and squeeze the rails with the vice.... it closes them right up to 50 gauge.
@jwhiteker1
5 ай бұрын
Surely his bottom rail was clear of the jaws, wouldn't ya say?
@Vizslarunner99
5 ай бұрын
Tightening them back up works, for about a day. Much better to just go up in gauge as the bar wears imo . Starting with .050 you have .058 and .063 next. After that I’d say you have got your use out of the bar.
@bobbynash282
5 ай бұрын
Good morning 🌞 from Alabama Leon. Thanks for all the help you give freely to us all.
@PaulaOwens-v4k
4 ай бұрын
hi leon what piston and cylinder for my homelite xl serial number 4296t044 type number 10003 i want to replace them
@markluxton3402
3 ай бұрын
That Saw Shop would benefit having an adjustable depth limiter. Then you grind till no more sparks and will have a perfectly even depth groove. Would require less skill to do a good job.
@blacksheep6285
5 ай бұрын
Nice video! I looked for a video on replacing shoes on a Homelite 540 & 8800 saw and found none? The saws been around 20+ yrs. maybe the shoes don't ware out!
@oologahgardentractorandcha3055
5 ай бұрын
I think the 196-D5 had that pin pattern to use on early 350 and 360 saws that the adjuster pin was a small rectangle
@LinkinMorehouse
5 ай бұрын
Hi, I was wondering if you had any advice fixing a Homelite C7 what I really need help with is I need to know what type of spark plug to get and what type of magnetron
@markluxton3402
3 ай бұрын
That roller tool to bring the groove together should be simple to make and improve. Does no one do so?
@markluxton3402
3 ай бұрын
Watching you hammer your bar in the vice....I have a solution. You need a thick bar of brass, maybe 1 to 2 inch squared, heaver the better. Cut a grove for the bar to sit in. Set the brass bar on something bigger and hard like a concrete floor or a heavy length of steel, say 2 X 3. The brass will dent instead of the bar steel.
@markluxton3402
3 ай бұрын
It may also be a good idea to get a brass hammer.
@BrucesShop
5 ай бұрын
Thanks Leon.
@wrayjordan8315
5 ай бұрын
Another enjoyable video! Thanks!
@Philjr-h7j
5 ай бұрын
Great video I like those bar Great information on the bars and repair advice I will keep in touch about more products and a chainsaw
Пікірлер: 19