I made my pump from a new GM old style V8. Used epoxy on the input shaft to hold a seal around the shaft. I used a 12 volt dc motor to line drive it directly. It hooked up to the truck battery , so I could pump out of anyone's barrels.
@Jimmyjimjim
9 ай бұрын
I have this mental image of an EPA employee watching this and just having an absolute meltdown.....
@Jeremy-de2of
9 ай бұрын
Vary cool setup man
@jpero9649
6 ай бұрын
I did the same propane tank setup except I heat the oil before passing through the filters, not sure what gave me the idea but it seems to work really well.
@gushardy4421
2 ай бұрын
What does heating the oil do?
@angusgraham3028
Ай бұрын
Evaporates water and also thins it out so it can flow through filters better
@nickreagan3083
3 ай бұрын
You should keep the tank inside in the corner so it won't be so cold
@antoniosestar3671
5 ай бұрын
I would distill that oil into diesel and sell it to make more money... already doing that where I live
@smokeybailey3080
5 ай бұрын
I like it
@jodym.2800
6 ай бұрын
Nice set up...
@spankranchgarage
6 ай бұрын
Thanks!
@SKIDLAB
9 ай бұрын
I use a washable mesh filter that fits in a standard whole house housing not sure what micron they go down too
@spankranchgarage
9 ай бұрын
That might be a good idea for my pre-filter. Ill look into them
@lnesland
2 ай бұрын
Nice setup. Do you mix the dirty oil with gas or diesel, to make it thinner?
@spankranchgarage
2 ай бұрын
I dont mix it intentionally but it really helps to. A few winters back I got 100 gallons of contaminated diesel and once I pumped that into my tank, the cold starts were way easier.
Пікірлер: 16