Airplane controllers for rc those UK guys are something else :)
@RBAERO
3 жыл бұрын
Important information. How much you open the top speed needle for the 5 initial tanks? And others configurations
@jtr4405
3 жыл бұрын
I'm about to break in my scuderia 721 and have a question but probably not worth asking if nobody's getting any responses by the looks of it
@redsracing1702
3 жыл бұрын
How can we help you?
@sendit2873
3 жыл бұрын
@@redsracing1702 I have quick one will the same engine in the video run a truggy the same torque and speed as a older nova .28 truggy as far as power and response
@jtr4405
2 жыл бұрын
@@redsracing1702 Do i let the engine cool down after each 1 of the 5 tanks at full throttle? Or run the 5 tanks at 90degrees continuous ?
@jtr4405
Жыл бұрын
Ok Elliot just to confirm we start our brand new engine cold with full throttle. How many hours do we open up the high speed needle during first 5 tanks on the box? And what temperature do we need the engine to be for the first 5 tanks and also what temp during the next 5 tanks on the track? ANY FEEDBACK OR RESPONSE WOULD BE MUCH APPRECIATED.
@royarsey5429
3 жыл бұрын
very nice ..Thank you ! and good luck racing !
@garykusnierz2108
Жыл бұрын
Thanks Elliott!!!
@supasmo
3 жыл бұрын
Is race ready fuel being used or higher oil?
@jtr4405
2 жыл бұрын
Do i let the engine cool after each 1 of the 5 tanks at full throttle ?
@godsun358
2 жыл бұрын
High speed break in... how many hours out did you set your needles from factory?
@shanemeyer9224
2 жыл бұрын
So quick question, the break in manual does not say to break the engine In at full throttle?
@ashermorales8276
2 жыл бұрын
I doubt it does but this is a fairly quick and easy way to break in an engine. Keep the engine up above 210-215° and really rich and it’ll break in just fine as shown in the video. Each person has their own break in method though. I do a similar thing accept I idle the engine for 4-5 tanks and then when I put it on the ground I limit how fast the car goes by how rich the high speed needle is for the next 4 tanks
@norcalrc
3 жыл бұрын
Good info. I subbed
@Reecefpv
2 жыл бұрын
Idk about all this. Why does every single video on break say to break in at idle and is one day ful throttle and the book even says idle not full throttle. That sounds dangerous. Just run it rich to get the oil flowing around. Does anyone else have any input on this? Lol sorry just bought my first nitro and watching a bunch of vids before I touch it lol
@ashermorales8276
2 жыл бұрын
The full throttle method of break in is the fastest, most effective way to break in an engine. You set the engine so rich that the rpm’s at full throttle are basically the same as a high idle. This gets the most amount of fuel and oil flowing through the engine possible and creates a very nice polish on the sleeve that makes a good seal. The most important thing to note about this method is that the engine cools off very very fast running that rich so you need to keep a heat gun on it pretty much the whole tank of fuel to keep it at least above 200°F. The ideal temp for break in is 210°F-240°F. Preheat the engine to around 250°F and it’ll drop down once the engine is running. Hope this helps 😃
@marklasky8786
Жыл бұрын
No else does this very unconventional break in. I wouldn't trust it.
@kiethpederson7558
5 ай бұрын
Every nitro engine I've had I've run one tank at idle then all following tanks all out there after not one issue at all .
@sendit2873
3 жыл бұрын
what is up with the airplane radio I have seen others in Europe do that
@TheEchelon
3 жыл бұрын
It's not an airplane radio... It's a stick radio for cars/ground. Prob 3, maybe 4 channels. Airplane radios are like 8 channels. Videogame controllers are also like that so it's not weird that some people prefer that type of transmitter.
@flubber781
3 жыл бұрын
airplane radio??? Its a Sanwa Exzes-zz stick transmitter for cars
@ahmadalojaiman9877
2 жыл бұрын
where is this track ? and which country
@terus1630
3 жыл бұрын
😍😍😍😍😍😍
@Statek63
2 жыл бұрын
What buggy is this ?
@burhan999
Жыл бұрын
can you please make RC more affordable 🙏?
@sts.556
3 жыл бұрын
5 tanks at full throttle ?
@TheEchelon
3 жыл бұрын
@DavidRC Use a heat gun for that... Very first tanks at full throttle just seems silly to me, but I guess it works for this guy.
@Early_2K
3 жыл бұрын
@@TheEchelon well he is a pro racer im sure he knows what he's doing lol
@s1edneck700
3 жыл бұрын
@DavidRC it’s actually quite a challenge to keep it hot at full throttle like that. With the volume of fuel required to prevent it from revving to the moon it cools the motor substantially. I did this method and had to keep a heat gun on it the entire time because temps would drop into the low 100’s.
@muggymaniac2.045
2 жыл бұрын
@@s1edneck700 heat gun. No problem
@littlemotor414
2 жыл бұрын
I just wrap the head in aluminum foil… Done this many times on top tier motors, and it’s the most effective for me… They wake up quickly, don’t waste fuel or plugs, and last close to 10gal before taking a gallon or so to go away… Then replace sleeve, piston, and inspect the rod… good to go all over again.
@simonpeterdalangpan9761
5 ай бұрын
5 tanks! 😂😅
@victoralcocer3926
8 ай бұрын
I see no responses from REDS or Boots to the questions here, so I doubt it. Poor explanation, no details at all. This video is a joke. I own a 721 3rd gen.
@redsracing1702
8 ай бұрын
for technical information we ask to contact us by email at info@redsracing.it
Пікірлер: 36