Hey guys, I'm performing a general flash/flush test of an XP600 Printhead that stopped firing my yellow. This is a general test that most of the chinese print controllers have. It's a super time saving test you can do to determine if your printhead is bad and will help you make a decision to change it, or to figure out what you can do to gain it back. PrintExp, Atools, KFPrinter etc controllers should have something like this available but asking support for it is the way to go, to find out. This method can be used for any printer with these type of setups. Hope it helps.
Referral Code: LAMARZZ2SYT
Michelle WhatsApp: +86 1376044 5602
Website: printninja3d.com
Contact Us: printninja3d@gmail.com (DM on the site page)
FB: PrintNinja3D LLC
Негізгі бет Refinecolor ZZ2F UV Printer - Troubleshoot the Printhead
Пікірлер: 2