Great content! We need more! It's difficult to find this type of content.
@tjaymacRC
24 күн бұрын
Appreciate that, thank you!
@rc4runner
9 ай бұрын
Thank you so much for all your videos. Very informative and helps a newbie like me. Keep up the good work
@tjaymacRC
9 ай бұрын
Awesome! Glad you find it useful. Thanks for the comment! 👍
@berryb0nzo
10 ай бұрын
Thnx again tjay! Keep up the good video's..
@tjaymacRC
10 ай бұрын
Thanks Danny! I have few other vides I made few months ago that I just never posted in Public. I will post them... I even have a battery comparison video. A good battery I used for the PN Regionals that I was testing beginning of June.
@almeriobarros
9 ай бұрын
Could you do one for Low Bite conditions, because our track is small (7 x5 meters), and more speed I do, more difficult to keep the car on track. I did all adjusts that I know, or someone advice me, If you have a great tip besides: diff set-up, use glued tire, taped tires, no glue no tape, ride height around 2mm, 1,5mm, 1,8mm, hard car, soft car....so, a new tip could be nice..great explanation!
@tjaymacRC
9 ай бұрын
More difficult to keep the car on the track? What do you mean? Like the car rolls over (traction roll)? I don’t have a track nearby that has low traction but I did went to a track few months ago with less traction than my local track. Before I explain on what to do, maybe answer my first question. Usually the issue of traction roll is 1. Tires are peeling off the rims or folding. 2. Driver is not smoothing out the off-throttle when coming into a turn and cranking the steering wheel (lock to lock style of driving).
@MelendezRacing
9 ай бұрын
Do you have the part number for the bearing to use the PN yellow gear on the Kyosho diff?
@tjaymacRC
9 ай бұрын
The spur bearing size is: 4x7x2mm. Here’s the PN Link: www.kenonhobby.com/PN-Racing-ABEC5-Dry-Ball-Bearing-4x7x2mm-for-Spur-Gear-2pcs_p_46346.html Here’s the PN Yellow Spur link. If you read the Requirements section of the page, you will see the bearing/s sizes specs: www.kenonhobby.com/PN-Racing-Mini-Z-2WD-Machine-Cut-Delrin-Limited-Slip-64P-PNWC-Spec-Spur-Gear-53T_p_46199.html
@Rx3
10 ай бұрын
Greetings, what setup board is that?
@tjaymacRC
10 ай бұрын
Hi, I had asked my friend to custom build this board for me in 2007. It was designed for MR03, it has 3 points where you can lift the MR03 and check for tweak and use the same holes for diff rebuilds.
Пікірлер: 14