Thank You Richard at 3:00 you say "i want to say this right" you then show and explain How to release the tension of a Stanly spring hinge. Thank you!
@absupplynet
4 ай бұрын
Thank you for your comment. Is there a specific question I can answer at this time? - Richard 773-809-3667 x 1112
@Mary-had-a-lil-farm
3 ай бұрын
Thank you thank you thank you. I was struggling and so frustrated trying to decrease the tension. Got it now 🎉
@absupplynet
3 ай бұрын
You bet and thank you.
@snuffeluffigis
8 ай бұрын
Sir thank you so much. You were right about having to go clockwise just a smidgen before you can turn it counter clockwise. Much appreciated.
@absupplynet
4 ай бұрын
Yea, pro tip. If it wasnt hard, they would not call it HARDware - LOL
@chococatreeves
3 ай бұрын
My issue was that the instructions showed removing the little lock pin, so without being able to do that, I didn't even bother reading the rest of the instructions. After watching your video, I now understand the following instructions and can say that removing the lock pin is unnecessary. Now to figure out how to get rid of the creak!
@absupplynet
3 ай бұрын
Try a little bit of lubricant: absupply.net/bommer-lubricant-for-all-spring-products-such-as-single-and-double-acting-hinges-and-pivots.aspx Not a guarantee but it always makes it a little bit better.
@1952mdmcc
2 ай бұрын
Thanks! I'd forgotten how to adjust these hinges that I installed ~15 years ago. Of course I have the instructions... someplace.
@absupplynet
2 ай бұрын
Tjhank you for the comment . After 15 years the hinges still work perfectly I imagine? Rich
@1952mdmcc
2 ай бұрын
@@absupplynet Yes, however I have 2 self-closing hinges on this door now (garage); originally there was only one which broke after about 7-8 years.
@absupplynet
2 ай бұрын
@@1952mdmcc Probably the top hinge broke. Never put a spring hinge in the top position. Swap the other two hinges every 5 years.
@TheCR1979
Ай бұрын
Thanks for the help!
@absupplynet
Ай бұрын
Sure thing - anytime - Rich
@TheJustinlampkin
Ай бұрын
I have a national hardware one that looks very similar but this does not seem to work on it. The instructions only say how to tighten it
@absupplynet
Ай бұрын
Have you tried the oppositwe of the "tightening" procedure to loosen the spring tension? If yes, did it work?
Пікірлер: 16