In this video I demonstrate my reinforcement of an inflatable Milka cow. It involves making a small slit in the toy; turning the toy inside out through that slit; and then gluing vinyl strips along each seam to span them. The toy can then be turned back right side out and the slit sealed. This leaves the toy with a stock appearance with little evidence of the reinforcement. After reinforcement, the inflatable is significantly sturdier and much less likely to break. If looking to strengthen a toy this is the method I would recommend.
If planning to do something like this yourself, make sure to do so in a well-ventilated room so as not to breath the glue fumes.
See my older reinforcing demonstration video here: • Reinforcing Inflatable...
Check out the full-length inflation video for the Milka cow here: • Video
Consider supporting my channel by buying a T-shirt: merch.heathdrag...
Visit my Twitter account at: / heath_dragon
While I love to describe the many projects I have done, if they inspire you to do something, you do so at your own risk. The glues and solvents I use can be toxic and vinyl is not breathable and can cause suffocation.
Негізгі бет Reinforcing an Inflatable Toy, a Milka Cow
No video
Пікірлер: 29