Read in SIS on how install injector proper procedure or you will damage the injector using rubber mallet and follow the torque sequence when tightening the base to avoid crack damage (aluminum metal)
@kfelix2934
2 жыл бұрын
Good job, one more tip this was. engine out on a stand and dry, in real life you would need a oil-fuel suction to evacuate any fluids that drains into the cylinder. Doing injectors is not that hard if you have the time and you can save hundreds of dollars in labor charges.
@belaybekele2625
2 жыл бұрын
Wow Very Nice
@1HSYURIDIA
3 жыл бұрын
Hi good morning Is there any way tobrelease oil o fuel pressure to chsnge fuel injector ?
@aeroguy86
7 жыл бұрын
I like to use a sledge hammer to seat my injectors!
@briansemder565
Жыл бұрын
Forgot draining oil rail before removing injector.
@devindermann8706
4 жыл бұрын
Never use a any tool to tap the injector dow just press down with u r thum and always lube up the orings with engind oil so i seats better n easy
@devindermann8706
4 жыл бұрын
Press it with you palm
@babyboylirazan9333
4 жыл бұрын
Do not follow that procedure check the SIS correct procedure don't applied any shortcut
@samgoldkoochu7944
4 жыл бұрын
1830691 is anybody can check this p/n please ? Is it for c7 engine
@Adam-fl5wm
Жыл бұрын
Bad advise, this is the content that should be removed from the internet
@Befikra_jatt
Жыл бұрын
Give me a job chans in. Your wrokshop sir bcoz i know cat injector repairing
@stanodom4579
5 жыл бұрын
Can yall not use air tools to remove things
@joshuamartin1522
5 жыл бұрын
In school we were not allowed to. They wanted to make sure that everybody knew how to do a job without relying on power tools.
Пікірлер: 16