Thanks for sharing. Would not have been able to get carbs off without pry trick!
@Oktavian1337
4 жыл бұрын
same here! Just did it, seemed impossible to get the carbs off without the pry trick!
@masonreese9177
3 жыл бұрын
Thank u very much, this was extremely helpful
@Vintage.Mindset
4 жыл бұрын
Great video, thank you.
@___Eldritch
3 жыл бұрын
Just grab the carbs at the top and pull back. It puts even pressure on all of them and won't loosen the connection from bending them by only pulling one.
@poloacosta2244
4 ай бұрын
Que pasa sino conectas esas 3 mangueras de arriba?
@charlesjohns3003
4 жыл бұрын
if you replace your hardened coller rubbers? which arent expensive, then apply a smear of sylicon grease to both the new rubber and alloy flange! the carbs will push on snug and not require any form of hammering!
@theunchartedmap
4 жыл бұрын
THANK YOU
@alberthunt8501
3 жыл бұрын
What holes did u plug up since you dont have the vaccum system on it?
@nicholasmartin297
2 жыл бұрын
Is the jumbo screwdriver a Philips or regular flat head?
@hankrodriguezhill7029
5 жыл бұрын
Thank you so much for uploading this very detailed video, will get couple thousand views ,only complain ,plz consider upgrading Camara quality besides that it's great video.
Пікірлер: 12