The Induction heater would be a game changer for you mate..... heat it up and use a screwdriver and a hammer.... bonus is that you can now use your tool (since you took the time to make it) and the heater and save yourself a lot of time
@SD-hl1sf
5 ай бұрын
Hi mate, how do you use the induction heater for a circlip? Does the item you want to heat up not have the be in the centre of induction end to heat up. Like a bolt head in the centre of the induction wire spiral?
@Humboldtcounty707
5 ай бұрын
@@SD-hl1sfYeah, that's what I was thinking myself. Plus, what if there's a seal and bearing that you can't melt it get hot?
@andrewhumphreys3911
5 ай бұрын
Thanks good tip I use a chainsaw file the other way round and spray it with liquid nitrogen
@TomTremayne
3 күн бұрын
That circlip then broke in there & you got it out in about three pieces........
@jaynicoll1662
3 ай бұрын
Lend us your tool mate 😂😂😂 ford kuga 2012, same problem, spose its tge same kinda hub lol
@chrismoore2971
3 ай бұрын
Haha I had a similar experience with my fiesta, after a lot of fire and banging the way that worked was to cut little slots in it all the way round with a dremel, then use a chisel to tap it out all the way around. That thing really didn't want to rotate in its groove. Now for the other side, then hopefully removing the outer races from the knuckle won't be too much of a challenge with the right tools
@MechanicLife-rx5ul
4 ай бұрын
Snap ring pliers
@lifeRobrandom
3 ай бұрын
Yes I've snapped many of them trying to remove a seized circlip
Пікірлер: 9