When I did mine I drilled into the weld then around the weld then used a hammer and chisel and had mine out rather clean in no time, any left weld I used a bigger hammer and flattened, then I painted the bare metal, didn't fancy sparks
@GDUBTV
4 жыл бұрын
Sounds very neat & tidy, thanks for sharing.. will give that a go if I ever do it again! 👊🏼🎥🚐
@dieselbushcraft1299
4 жыл бұрын
I just finished this job, I removed seats too but left drivers base but I was running wiring and fitting a battery. Far easier with seats removed. Have to be careful with the sparks as these can melt into the glass.
@GDUBTV
4 жыл бұрын
Ace, well done 👍🏼🎥🚐
@ROLYTHETAXI
4 жыл бұрын
Melt into the glass is correct and paint, plastic etc
@davidthrower99
11 ай бұрын
I’m doing this this weekend. Thanks for the video mate. Very helpful. I’m taking the seats and cabin mat out as I’m going to have a good dig out
@chrisjones6017
4 ай бұрын
Just use a spot weld drill bit
@truckdriver131
3 жыл бұрын
Top man!!! I was wondering how can I get it out? Now I know exactly!!! Thanks for Sharing!!!
@GDUBTV
3 жыл бұрын
No problem 👍
@clfehr08
3 жыл бұрын
You’ve managed to do this a lot quicker than me! I removed the seats, pushed back the ‘carpet’, pulled up the ply floor, and ended up taking a lot of time to grind down each weld. I avoided making any holes and left it all pretty smooth. Just putting a second coat of metal paint on tonight. I know it’s all covered up… so not sure all the extra effort was worth it! Took me bloody ages. I think I’ll be fitting a double swivel seat and some other bits while it’s all in pieces.
@russcurrie72
4 жыл бұрын
Another cracking video Gordon 👌😃
@GDUBTV
4 жыл бұрын
Thanks Russell, really appreciate the encouragement mate 👍🏼🎥🚐
@fpvlee1586
4 жыл бұрын
Pls cover your glass 🤦🏼♂️
@davidthrower99
11 ай бұрын
I’ll be covering my glass when I do it!!
@kevinmulligan9055
Жыл бұрын
You can buy a spot weld removal drill bit. Then no need for grinder. Might be better option.
Пікірлер: 24