I battle to remove a hard stuck crank arm with damaged threads. I managed to get it off. If it hadn't come off when it did, my next step was to heat up the crank arm with a heat gun while the puller had it under pressure. The aluminum might have expanded slightly allowing it to break loose.
p.s. Pre-1982 Stronglight cranksets used a 23.35mm puller tool. But this was a later model that takes a common 22mm puller. The drive side came off off fine with the Park Tool puller.
The three jaw puller used in this video is a 4" puller from Harbor Freight.
▶ SUBSCRIBE & HIT THE 🔔 bit.ly/SubRJTheBikeGuy
👍 And please give my video a thumbs up 👍
▶FACEBOOK.com/RJTheBikeGuy
/ rjthebikeguy
▶TOOLS
www.rjthebikeguy.com/tools
▶SHIRTS
bit.ly/RJBikeGuyShirts
▶WEBPAGE
www.RJTheBikeGuy.com
Негізгі бет Removing VERY Stuck Crank Arm With Damaged Threads
No video
Пікірлер: 347