Thanks. I hit the thin wire on the transponder, too. However, I managed to solder together the thin wires themself and make the antenna work again. It was a bit shorter than before but does work anyway.
@sameralquraishi777
12 күн бұрын
Is that possible? I have the same problem and I don’t know how to do it
@reiben6924
12 күн бұрын
@@sameralquraishi777 It worked for me... do you know how to solder? I unwinded the wire until it ceased to be broken. Then I took some of the longest pieces of the wire and scraped the insulation from the two ends with an exacto knife - a few milimeters was enough. I dipped the ends into the solder flux first, then I applied heat with the soldering iron and covered the ends with some tin. After that, I put those ends together and applied heat so they would stick together. I repeated this process until I soldered on all the longer pieces (looking back now, I don't think putting all those pieces back on was even necessary). I glazed the soldered parts with some transparent varnish for insulation. My coil still had one end of the wire connected to one of the two contacts so I knew which wire goes where. I simply soldered the end of the free wire to the free contact - after winding it all back on. Hope that helps.
@markanderson8146
Жыл бұрын
Worked perfectly thanks!
@Djxhdhf
11 ай бұрын
Mērssi
@jordanbuscema2719
7 ай бұрын
i also fucked the antenna haha how do i fix it?
@francescomusso9409
Жыл бұрын
Great tutorial! Many thanks!!
@gregorvanegdom
Жыл бұрын
Hope it helps keeping another one going :)
@charliereilly2748
4 ай бұрын
Nice one 😁👍
@jordanbuscema2719
7 ай бұрын
i also fucked the antenna haha how do i fix it?
@gregorvanegdom
4 ай бұрын
did it come loose or did you cut the thin enameled wire? spare antennas can be bought for a € or so on ali etc.
@jordanbuscema2719
4 ай бұрын
@@gregorvanegdom yeah i changed the antenna and its working great.
@sameralquraishi777
12 күн бұрын
Is that possible? Can I just change it without needing to programmed? It will, works?
Пікірлер: 14