What I found to help get the bushing over the sway bar easer was to put the new bushing in boiling water for about 5 min take the pan of water to shop with bushings still in water use extra caution with hot water use gloves and tongs to take 1 bushing out at a time it will go over the sway with a lot less trouble repeat with other this works very well
@10947792
3 жыл бұрын
A brilliant idea!!! I wish I would have thought of that before I fought that bushing for way to long.
@jaysmitty6158
3 жыл бұрын
Great content
@EdwinRodriguez-il6pk
2 жыл бұрын
Both of my ends snapped lol idk how to start 😂
@carlosluis1406
2 жыл бұрын
how tight should sway bar bushing be?? Lb/ft
@10947792
2 жыл бұрын
I don't know the manufacturers torque specification.....I just tightened them till I couldn't tighten them any more.
@ThisOldYota
3 жыл бұрын
Just did this on my wife’s ‘10 Acadia, those bushings sucked getting in an out while in the garage. I have no idea how you were able to all the way under there
@10947792
3 жыл бұрын
you're right, it was a difficult place to get to with the vehicle on jack stands....Especially while trying to do a decent job at filming it too. Hopefully I was able to help a bit.
@TyzFix
2 жыл бұрын
do you mind sharing the brand of the new sway bar links? thanks!
@10947792
2 жыл бұрын
Tony, the bushings are from Moog and I think I purchased them thru Rock Auto.
Пікірлер: 10