**IMPORTANT UPDATE: Make sure to mark the drive shaft at both ends in relation to each other as well as the vehicle so that orientation is exactly the same when reinstalled.**
If you hear unusual noises (howling) or feel shuddering when you accelerate, there is a good chance your center support or carrier bearing needs replacement. Josh takes you step by step through the process of removing and replacing the center support or carrier bearing on a 2010 (same for years 2007 - 2013) Toyota Tundra without using a.
The general principles of this video will apply to most rear wheel drive vehicles but the specific details may vary.
Job Summary:
-Remove drive shafts from vehicle
-Separate shafts at universal joint
-Remove old bearing
-Install new bearing
-Reattach shafts and reinstall on vehicle
Tools Needed:
-Jack & stands
-Socket set
-Oversized socket (size depends on model/year)
-Wrench set
-Impact gun
-hammer
-Straight screwdriver
-Pliers or vise-grips
-Needle nose pliers
-File or sandpaper
-Grease
Optional: Bungee cord, grease gun
- Please if you like this video do us a solid and subscribe. It enables us to continue making useful videos! Thank you and thanks for watching!
Негізгі бет Тәжірибелік нұсқаулар және стиль Replace Center Support or Carrier Bearing on Toyota Tundra Tacoma ,No Press or Special Tools U Joint
Пікірлер: 201