Hi there, how did you end up replacing it? Did the clutch didn’t let you shift into gears when you step onto the clutch? Did the clutch feel a lot softer than normal?
@davidmoss1012
6 жыл бұрын
replacing master cylinder in this car is the worst thing which happened in my life so far.
@foreverwood1963
6 жыл бұрын
OMG My wife's is acting up oh no!
@0for30
6 жыл бұрын
@@foreverwood1963 hhahahaha
@avidpain
6 жыл бұрын
how bad was it really? access any easier coming from the bottom? or is the struggle really just lining it back up on reinstall
@martinschmitt463
6 жыл бұрын
Blake Dailey it’s a bitch, I did it yesterday and I wasn’t able to reach my hand back there to get the line off so I took the whole thing out with the line around from the bottom then I put the old line on the new master and wiggled it back in there it was very fucking frustrating
@1314zerosktr
5 жыл бұрын
If that's the worst you've had to do, better pray you never have to change the VTC solenoid LOL
@fishkeeper7960
2 жыл бұрын
Tha slave cylinder from kserie is different than tl v6 and 4 cylinder are different the master cylinder pump are the same
@Stevesbe
4 жыл бұрын
It's best to replace the master cylinder on the 2003 to 2007 accord with one from the civic the design is much better and doesn't fail. Even if you buy OEM Honda parts the they don't last . These civic MC fit with no modification EXEDY MC553 Automobile Clutch www.amazon.com/dp/B0049TWHPY/ref=cm_sw_r_cp_apa_i_DmB7Db4CRE5BW
@morecowbell235
Жыл бұрын
slave cylinder for 91-95 acura legend is so hard to reach. under car, next to tranny, blocked by bracket and partially blocked by exhaust pipe. Very difficult to get to.
@joehowto
Жыл бұрын
Mine is also very difficult to get to. Lots of cuts on my arm.
@foreverwood1963
5 жыл бұрын
I'm hearing everyone state how horrible this is Joe how did you find it?
@kenxu346
5 жыл бұрын
Hi! When u take out the cylinder for the brake booster do u have to take off the hard lines too? Thank you!
@joehowto
5 жыл бұрын
Ken Xu no, just bent the line a little bit
@rustilldown4me
5 жыл бұрын
Was your master clutch cylinder leaking? Why did you change it?
@joehowto
5 жыл бұрын
rustilldown4me no but it makes noise when pressed down the clutch.
@rustilldown4me
5 жыл бұрын
@@joehowto ok thnx
@rustilldown4me
5 жыл бұрын
Does replacing these parts fix the first and reverse issues like grinding in reverse and getting into 1st at a stop light?
@joehowto
5 жыл бұрын
rustilldown4me depends, if it is the master cylinder problem. If not, it can be the clutch or pressure plate problem.
@fishkeeper7960
2 жыл бұрын
This is a kserie 5 speed manual transmission
@matthk
Жыл бұрын
this video is all over the place, and you're not TELLING the viewer anything. Are these different cars? What the hell is going on??
Пікірлер: 31