In this video, I show you how to detach an outboard tailpiece and replace it after the impeller.
I did this video in two parts, otherwise it might be too long.
Normally, the outboard should have a cooling jet at the rear. However, if this is not done, the impeller may be broken. and you will have to replace it.
the tail of an outboard motor is quite difficult to remove.
You should also remember that the gasket does not break.
Bo's Instagram is www.instagram....
SLOEPNED WEBSHOP:
www.sloepnedwe...
FOLLOW US on Instagram:
/ martijn_heere
LIKE us on Facebook:
www.fb.com/mar...
SUBSCRIBE to KZitem:
/ sloepned
and don't forget to click the bell to receive notifications!
Негізгі бет Replace impeller and disassemble tail Outboard motor (part 1)
Пікірлер: 51