Replacement of the metal-rubber bushing in the front arm of the Hyundai I30 after 2011.
All bolts were quite heavily corroded, which significantly extended the repair time. Breaking the sleeve out with a hammer or squeezing it with a vice would be very difficult due to its diameter of about 70mm and the degree of corrosion. Press "Like" 20T and you had to pump the cylinder hard. I did not use a pin puller to show that it can be done without even if it is corroded.
Негізгі бет Автокөліктер мен көлік құралдары Replacement of the front control arm on the Hyundai I30
Пікірлер: 8