You think I could weld a nut to a snapped vane spring mount to get it off?
@yourlocalwellman
4 ай бұрын
I'm assuming you mean the part that sticks out of the base of the motor that you slip the spring onto from the tail. In that case, I don't see why that wouldn't work! I would try a pipe wrench on it. Probably would get it off, too!
@kmeyer5598
10 ай бұрын
Was the replacement a new or rebuilt motor?
@yourlocalwellman
10 ай бұрын
This one happened to be a rebuilt motor!
@johnykurmis3271
9 ай бұрын
How much water daily in gallon's are you getting and how much gallons per minute douse it give approximately ?
@yourlocalwellman
9 ай бұрын
That depends on a decent amount of variables, what size the check and plunger are, how deep the well is, and what motor head they have one but on average a 2 3/4 plunger can pump 3-5 gallons a minute on a good day
@santiagopenonori6299
9 ай бұрын
Hi, i am from Argentina and i have a question. How can i know where my aermotor windmill will can has a scape of oil? And how can i fix it? Thanks
@yourlocalwellman
9 ай бұрын
Hi! And are you meaning there's a leak that you can't find?
@theozarkhillbilly9040
10 ай бұрын
What's shot about this one?
@yourlocalwellman
10 ай бұрын
Little gears in the back went out, so the two sets weren't touching!
@theozarkhillbilly9040
10 ай бұрын
@@yourlocalwellman wow. How many years you reckon its been up and running?
@yourlocalwellman
10 ай бұрын
It's hard to tell. I couldn't find a date stamp on it, but probably in the 20-25 year range if oiled properly
Пікірлер: 15