nice i did the same thing with my airless wheels last week✅
@da420burna
4 ай бұрын
That’s a bob the builder hammer 🤣
@Thec0nv1ct777
4 ай бұрын
Perfect timing cuz the bearings in my meepo cyclone hubs are near impossible to get out
@jimbo4068
4 ай бұрын
I did exactly the same yesturday😁👍🏼
@BrettGurewitz
4 ай бұрын
what if the bearings have built in spacers? also what board u riding with those?
@Allebaggen1
3 ай бұрын
Do you use your 115mm rubber now? If I remember correctly I read somewhere u didn't like them so much and you are the one that have tried the most wheels out there! I like both the 115mm rubber and the 105mm mad wheels.
@user-no2lm2iy7y
3 ай бұрын
I have the smaller bearins that came with my Acedeck Stella . Can I put larger bearings to accommodate the bigger Acedeck N3? 8mm to 12 mm I think it is?
@BrettGurewitz
4 ай бұрын
Thanks!
@WorldwideDarts
4 ай бұрын
That was kind of you. Do you like darts too? 😂
@wilsgrant
4 ай бұрын
What if the bearings you installed have integrated spacers?
@BN99239
4 ай бұрын
That's going to be tough. You just have to keep heating it up until it's loose enough and try to put a towel or some kind of padding on the bearing as you put a screwdriver at it and try to knock it out. With this amount of heat, I'm not sure how the bearings will even hold up. If you're just getting old bearings out to throw them away then that's fine, but I wouldn't want to reuse bearings that have been heated up this much.
@stephenhartley3292
4 ай бұрын
Probably better to use a pin punch and a more manly hammer
Пікірлер: 13