Very helpful video indeed. Getting the shaft out of the housing is a major head-ache. I used a lot of patience and WD-40 and a rubber mallet...
@OMAIRS-nf3sw
3 ай бұрын
Thanks for the video 👍
@juicer52
Жыл бұрын
If that retaining clip is hard to loosen/corrosion welded to the plate, you can look through one of the air vents on the side and tap the clip with a thin screwdriver. Likewise, when reassembling, you can peek through the vent holes and make sure it isn't blocking the reinsertion of the armature.
@CynthiaNakaya
Жыл бұрын
Thanks for the video.
@marcosperales7349
Жыл бұрын
You're welcome
@addaeus11
Жыл бұрын
I use the old bearing to sit on top of the new bearing and then bang it on
@Jared_Albert
10 ай бұрын
Thank you!
@MariJani1
7 ай бұрын
I got my women power. Gracias Your video was super helpful,I appreciate it.
@nunya6379
4 ай бұрын
Can I use my old bearings from my old pump if they r the same exact pumps?
@marcosperales7349
4 ай бұрын
If they're in good condition, of course. New bearings are usually pretty inexpensive though.
@DanOKC
2 ай бұрын
New ones are so cheap why would you? Why repair with bad parts?
@derekdriver251
4 ай бұрын
Where did you get the bearings
@marcosperales7349
4 ай бұрын
Amazon.
@JAYY_JAYY
10 ай бұрын
What is the cost to rebuild one of those ?
@marcosperales7349
4 ай бұрын
It depends on the size of the job. If I'm only doing this... 250.00. Sometimes, the bearings are hard to get or expensive. Remember to judge whether the job is worth it or not.
@jwhite26
21 күн бұрын
You lost the spacers
@ML-dc4qw
2 ай бұрын
Useful info, but not a smart work surface.
@marcosperales7349
Ай бұрын
Perfect for my shortness
@weldonlilley
6 ай бұрын
This is a poor excuse on showing people how to replace brgs u didnt dhow anything about the govenor switch
@marcosperales7349
5 ай бұрын
There is no governor switch. Single speed? Single capacitor.
Пікірлер: 20