OMG! Finally. A video that just shows you what to do. No shaky one handed repairs, no useless commentary, just the steps you need to do to complete the job. Thank you.
@derektitov6667
3 жыл бұрын
I've been lucky enough to not have to worry about power steering pumps on any of my vehicles so far, but it was cool to see how it's done. Nice work!
@Benz-rz7bo
Жыл бұрын
Finally could afford a new pump w resivor and got all my tools now.....time too give it a shot thanks for this video ad it Def gives me confidence going in
@DeeStruggles
Жыл бұрын
Let us know how it works out..
@denisvandoorne6335
3 жыл бұрын
Thanks bro! Walked me right through it with ease!
@mikeduchateau40
Ай бұрын
good video verry informative
@justmaccarreviews6240
3 жыл бұрын
Jack the car up and turn the wheel with it off. To bleed the air.
@timothyarmbruster8325
3 жыл бұрын
Helped me out alot...thanks bro.i have the same car.but I dont have motor mount in the way.so I lucked out.
@scottysblog7317
Ай бұрын
I get the same kind of sound when I turn my steering wheel to the right on my 2004 Pontiac Grand Prix GT2. It's not leaking any fluid, it just whines bad.
@buckkerz
2 жыл бұрын
I just need to tighten the pulley. Do I have to take all that off? You know I'm about to try not too lol hope I don't fuck some shit up lolzzzz fr bro dudes in auto zone didn't even know what the kit was. Good shit man. Why people even go to school anymore lol someone can help me do even my taxes online lololol I'm a software designer but I swear I can't take a whole car apart and put it back together perfectly. As long as someone else is paying of course bahahaha good job man! Sizes would have been cool of course but this is the best video I've found. I'm very thankful!!!
@DeeStruggles
2 жыл бұрын
the airbox and maybe the motor mount to get the installer tool on to tighten it…
@DEREKSHAUN
Жыл бұрын
@Dee Struggles what was the part number for the resevoir seal you put on?
@prodbycoraun243
2 жыл бұрын
Dang no mention of a single bolt size in this video
@mlthmp
3 жыл бұрын
Would it be the same for the 3.9L V6 also?
@connorwhitaker8068
3 жыл бұрын
Good vid, whats going on with the maro?
@CarlosGonzalez-ch6xw
Жыл бұрын
Hey man when you install the high pressure line back did it have two o-rings or just one. The one in the tip
@diorsimmons2059
3 жыл бұрын
@DeeStruggles What size wrench did you use to release the pressure on the belt and for the three bolts on the pump? Does anyone else know too?
@comicbookguy7583
2 жыл бұрын
HELPPP! My GF jump started this same G6 backwards +to- ..says battery poles became red hot, I'm sure the Alternator is fine but l can't locate the FUSE or any burnt wires ! :( ps..its a 100% new battery
@tetrisplayer117
3 жыл бұрын
Where’d you buy the pump from? I can’t find it anywhere
@yehaw6811
Жыл бұрын
Bro I need to know how to take the lines off I’m struggling with this shit
@linaresamber
2 жыл бұрын
what size were bolts or what size tool did you use?
@bbentertainmentpearlgangba4463
2 жыл бұрын
How much would you charge me to do the same the to my G6
@ChrisBryant-s5p
7 ай бұрын
You didn't flush the system out
@roamizane1484
3 жыл бұрын
What if it have a whine with no leaks nor hard steering?
@cbar30
3 жыл бұрын
Probably dirty fluid, flush and replace with fresh fluid
@mizerrocker
2 жыл бұрын
@@cbar30 Making noise not low on fluid noise only when turning how do you drain ?
@benjaminschutz727
Жыл бұрын
Might want to change those MAF wires too. They look like shit
Пікірлер: 27