Don`t know if you still watch the comment section . I will have to do the same job tomorrow on my hornet pc 34 and this videos are very informal and straight forward , thanks !
@DaHitch
2 жыл бұрын
Glad to hear you found it helpful!
@MatasK
5 жыл бұрын
Had same issue with back sprocket. Went to service with a wheel to take em off
@EmilAleksandrovv
6 жыл бұрын
15:38 these nuts
@lukeliablephoto
3 жыл бұрын
What size of chain did you use?
@crankybear1236
2 жыл бұрын
Next bike I will get well definitely be shaft drive 😂
@DaHitch
2 жыл бұрын
I still own this bike, but I swapped out my daily for a shaft drive as well. :D
@crankybear1236
2 жыл бұрын
@@DaHitch cool
@diegoperez2912
2 жыл бұрын
Amigo,jamás se usa una dinamométrica para aflojar. Esa dinamométrica no vale ya para dar el par de apriete correcto,está descalibrada. Otra cosa,antes de desmontar cadena,aflojar corona y piñón
@MrJimbo1310
6 жыл бұрын
what does changing the sprocket size do again?
@DaHitch
6 жыл бұрын
Decreasing size at the front/increasing size at the rear increases torque on the wheel but lowers top speed. Increase size at the front/decrease size at the rear reduces torque on the wheel and increases top speed.
@MrJimbo1310
6 жыл бұрын
Is there a reverse so better top end?
@DaHitch
6 жыл бұрын
Yes, but it's always a tradeoff. Either your decrease top speed, but increase accelleration (smaller front and/or larger rear), or you get higher top speed, but slower acceleration (larger front and/or smaller rear). When you're changing gears you're always trading in one for the other, if you want both you need a bigger engine. ;)
@Panchdara
6 жыл бұрын
Let's not forget that the speedometer will be affected too - the pickup is driven off the front sprocket so the speed reading will be way off now too. SpeedoHealer will sort that out.
@Panchdara
6 жыл бұрын
@ DaHitch - That's why there's the CB900F-x :)
@Ladosligese
3 жыл бұрын
so you want more acceleration ? .. on a hornet 600 .. sure ok .. well :D
@DaHitch
2 жыл бұрын
This bike was used for gymkhana competitions, so top speed was irrelevant, but it needed even more acceleration, even when below 5k rpm where the Hornet can feel a bit lacklustre.
@MZMotor95
5 жыл бұрын
I'm sorry, I usually restrain from commenting negative opinions, but I cant help it right now. You don't seem to be very good with mechanical stuff, and I would definately consider bringing a friend to help you next time, or maybe let a dealership do this for you, even though chain and sprocket replacement is fairly easy to do. Just my 10 cents on the matter... good luck. Nice bike though! :)
@vicisrussian
5 жыл бұрын
what a prick
@DaHitch
2 жыл бұрын
At the time of recording I was a truck technician, so either I was a bit more proficient than you give me credit for or my bosses were incompetent for hiring me. I'm a prototype vehicle technician for the same company now so I guess I must be doing something right. Or, you should feel very afraid when you're driving behind a truck.
Пікірлер: 23