Great video, just found my cv joint is leaking on my new second hand jimny. This is a great instruction guide thanks 🙏
@oferel79
5 ай бұрын
Just replaced cvs on a gen 3, holding the half shaft vertically in a vice and a good hit to the casing did pop the circlip easily for me. No cutting needed😊
@chattonlad9382
2 жыл бұрын
Thank you for that Martin.
@user-oc6wi3tg1h
2 ай бұрын
了解,謝謝分享!
@solino2002andrea
Жыл бұрын
Hi Sir, may I kindly submit your some questions? Why did you cut old cv joint? If it’s kept in place just by a circlip, could be possible to separate the two shafts just by pulling? Why it’s not convenient to fill al the “cup” with “waterproof” grease? Why the replacement kit comes with new kingpins as well? Do they wear? Aren’t they quenched and tempered? They does not move at all… I undid lower king pin in order to replace it with an adjustable one. When I pulled it out a half liquid grease came out (just that side). Does it mean driveshaft seal is leaking (grease mixing with diff oil)? Diff oil level seem just 1 millimeters below filling plug. What do you think about adjustable kingpin? Thank you in advance.
@bigjimny
Жыл бұрын
As I said in the video, none of the techniques for getting it off by releasing the circlip worked for me, so I just cut it off. The new CV joint is already packed with the correct amount of grease so ists not possible to add more. The repalcement kit doesnt come with new kingpins, I just repleaced mine as they wear over time. Adjustable kingpins are a waste of time. Just change the bearings when they are worn out and add a shim if necessary. If you joint is leaking then the driveshaft oil seal is leaking and should be replaced.
@phillmcaverty
9 ай бұрын
Nice video
@robertlogan2257
Жыл бұрын
Nobody does it better.
@hanshomesteading1276
6 ай бұрын
My Jimny's seal is leaking. would you recommend just replacing the seal and top off the differential? or dismantle the whole thing?
@bigjimny
6 ай бұрын
I would recommend finding out what is causing the oil to be in the joint in the first place. The large "seal" on the back of the Swivel joint is not a seal, it is more a dust cover and there should not be oil in the joint, it is a dry joint normally. You will have worn Kingpin bearings or worn wheel bearings or a damaged CV joint causing the oil leak.
@sinnakjell7077
Жыл бұрын
Did the vented disc upgrade do any good? running 35"s now, and i really need better breaks, but i cant modify to rear conversion as its not legal here. bigger bolt on in front would be better. any ideas? great videos as always
@bigjimny
Жыл бұрын
When driving it, it is hard to tell is been done. However in the MOT test brake efficiency it goes from a just pass 40%?? to a good 70%
Пікірлер: 13