Just did this on a stock xj. Got fed up and pulled the axle out. :) smooth sailing after that haha
@jamesstutts1681
2 жыл бұрын
cant believe you skipped the part of actually taking the oil pan out... point of the whole video
@seanmacdonald8476
2 жыл бұрын
You're right. Mistakes were made my b
@jamesstutts1681
2 жыл бұрын
@@seanmacdonald8476 it’s all good
@drgil65
3 жыл бұрын
Any issues with the oil pan and gasket since this video?
@crackedheadauto5932
3 жыл бұрын
Only a small leak because I actually stripped one of the bolts over tightening it after I stopped filming. I never put in a helicoil or rethreaded it
@aidancanny6231
2 жыл бұрын
would you need to replace the gasket too?
@Hans-fq4ip
4 жыл бұрын
Was is your jeep lifted? I need to replace my pan gasket on my stock xj
@seanmacdonald8476
4 жыл бұрын
Yes about 4". Good luck, I've heard folks have done it with jack stands and some magical maneuvering of the axle but quite frankly it's gonna be tight and you'll probably invent a few new curse words.
@seanmacdonald8476
4 жыл бұрын
Oh and you might have to disconnect the oil filter!
@jakehoward895
3 жыл бұрын
Did you ever end up putting that metal bracket back on?
@seanmacdonald8476
3 жыл бұрын
Nope and all good
@trailwindz7833
2 жыл бұрын
How many quarts of oil does it take?
@evanrishel8513
Жыл бұрын
6
@luisgapr
3 жыл бұрын
Hi, you need remove the exhaust and starter to remove the oil pan? Thanks
@WAEMIDIV
3 жыл бұрын
Removing the starter will make it easier, removing the exhaust is not necessary
@floresluis9217
Жыл бұрын
@@WAEMIDIV how did you get the bolts closer to the transmission and the exhaust y collector if you remember I'm doing mine and I'm stuck at that part any pointer would be appreciated
@WAEMIDIV
Жыл бұрын
@@floresluis9217 I used various extensions and swivel extensions
Пікірлер: 20