DIY on #Jeep #JK #Wrangler and replacing the #Water #pump. It is an easy process and you only need a few tools.
**TIPS**
Drive the truck to operating temperature. The block is aluminum and the bolt fasteners are steel. If you do this job when it’s cold, you run the risk of snapping the bolt heads off. I’ve done that before on my old JK. Aluminum block expands when it’s hot and shrinks when it’s cold making it harder to remove studs.
Duration: 2 hours or so depending on skill level
Tools needed:
Torque wrench
10 mm bit
13 mm bit
3/ 8 ratchet
Extension
Some kind of bucket
Gloves
Leave your comments below for the group and like/subscribe to the channel.
Негізгі бет Replacing
Пікірлер: 43