This video shows the rear wheel bearing change on a Mazda 3 from 2006.
The tool used are:
T-50 bit
5mm ratchet
14mm ratchet
14mm Hex-wrench
At the beginning you should definitely make sure that the vehicle is stable and secure on jack-stands.
Under no circumstances should the car during the repair tip of the supports in order to avoid injury!
After the wheel and the brake caliper has been removed, it is helpful to spray the four bolts with penetrating oil. This makes it easier to remove the bolts.
Alternatively you could heat up the area with a torch. As a result, the bolts will loosen also.
During assembly, make sure that the connector of the ABS sensor is plugged in again.
Also, I would advise to threaten the bolts with Loctite, so they do not loosen by themselves.
Music: “The Creek” by “Topher Mohr and Alex Elena”
Негізгі бет Replacing Wheel Bearings on a Mazda 3
No video
Пікірлер: 19