Thanks Anthony it's a challenge for me it's part of what I enjoy doing Beyond woodworking. I love seeing things come back to original condition.
@lezao
6 ай бұрын
I love restorations !
@henrymostert2125
6 ай бұрын
Very satisfying aren't they
@nathansilver9190
6 ай бұрын
Hey Henry, very informative. I have a 12" slider just like that one. My problem is when I go to change the miter table, its very tight....not smooth. What's your prognosis? Thanks man, I always look forward to your content. Greetings from Washington State.
@henrymostert2125
6 ай бұрын
Hi Nathan. I would suggest that loosen that bolt that's just behind the throat plate. Loosen it up enough so that you can lubricate the sliding table. Once it moves freely then tighten up that bolt and see what happens.
@nathansilver9190
6 ай бұрын
@henrymostert2125 Thanks Henry, I'll give it a shot.
@henrymostert2125
6 ай бұрын
I was just thinking one last thing when you loosen that bolt off take your compressor and blow that area out underneath. It may have sawdust and a mixture of metal filings from moving the table
Пікірлер: 8